Abstract:Abstract Cryo-compressed hydrogen storage is a novel on-board hydrogen storage technique. It possesses a higher hydrogen storage density and prolonged dormancy periods. Cryo-compressed hydrogen storage cylinder is the primary component for on-board hydrogen storage, where the inner cylinder with carbon fiber fully wrapped aluminum liner (Type III structure) is directly contacted with hydrogen. However, the extremely low temperature and high pressure conditions can potentially lead to damage and failure of the fiber-wrapped layer in inner cylinder. In current literature, existing research did not clearly define the variation in pressure-bearing capacity of the inner Type III cylinder after low-temperature treatment, nor the distribution and evolution of internal damage in the fiber-wrapped layer after low-temperature treatment. In this study, a inner Type III cylinder of cryo-compressed hydrogen storage cylinder with a volume of 55L and a nominal working pressure of 35MPa was prepared. After subjecting to a 16-hour liquid nitrogen treatment, a significant increase in defect density in the body of cylinder, and new delamination and matrix cracking in both heads were observed through industrial CT detection. Finally, the residual pressure-bearing capacity of inner Type III cylinder after liquid nitrogen treatment was examined through hydrostatic burst test. This study examined the influence of low temperatures on the inner Type III cylinder of cryo-compressed hydrogen storage cylinders, and also provided a guidance for the failure analysis of cylinder at low temperature conditions.

Variation of interspace pressure of cryogenic tanks after liquid filling

Experimental study of self-pressurizing transfer system for cryogenic liquid

Investigation of the Chill-Down Behavior and Thermal Stress Distribution of a Cryogenic Tank During the Filling Process

Influence of filling methods on the cool down performance and induced thermal stress distribution in cryogenic tank

Damage Assessment of Liquid Nitrogen Filling on Type III Cylinder in Cryo-Compressed Hydrogen Storage Cylinder

Analysis of a New Self-Pressurization Model for Cryogenic Fluid Tank

Experimental study on cool down characteristics and thermal stress of cryogenic tank during LN2 filling process

Numerical Study of the Filling Process of a Liquid Hydrogen Storage Tank under Different Sloshing Conditions

Investigation on Performances of Non-Loss Storage for Cryogenic Liquefied Gas

Experiment and calculation to the pressure change in the process of cryogenic liquid non-loss storage

Numerical investigation of no-vent fill process of cryogens under microgravity condition

Thermodynamic Analysis of Partially Filled Hydrogen Tanks in a Wide Scale Range

Simulation on chill-down behavior and induced thermal stress of a cryogenic tank during LN2 filling

The effects of vertical and horizontal placement on no-vent fill of cryogenic insulated vessels

Numerical Investigation of Pressurization Performance in Cryogenic Tank of New-Style Launch Vehicle

Experimental Study on Thermal Stress of Cryogenic Tank During Different Cool Down Process

Finite element analysis of strength of mobile cryogenic LNG storage tank

Thermal stratification and self-pressurization in a cryogenic propellant storage tank considering capillary effect in low-gravity

Numerical Simulation on Interface Evolution and Pressurization Behaviors in Cryogenic Propellant Tank on Orbit

Theoretical and Experimental Study for Static Evaporation Rate of a Self-Developed Liquid Hydrogen Storage Tank

Simulation of vaporization process inside cryogenic liquid oxygen tank for long-term storage in orbit