Abstract:Grate-fired boiler is of considerable interest for burning biomass owing to its reduced sensitivity to variations in fuel composition and size. However, grate-fired technology exhibits unsatisfactory performance in terms of combustion efficiency, contaminant emissions, and flame stability. CFD modelling can provide reasonable optimizations to overcome these drawbacks and ultimately achieve clean and efficient energy production. Conventional approach simulates the fuel-bed and freeboard combustion separately using an in- and over-bed coupling procedure, where data of the gases leaving from the packed-bed top and the radiative heat flux emitted by the high-temperature flame onto the bed cannot be interacted in real-time. This may cause distinct deviations in the calculations. In this paper, a three-dimensional (3D) full-scale integrated model is developed for the simulation of grate-fired boiler, in which the intensive combustion of both the freeboard and fuel-bed is solved in one scheme using the Eulerian-Lagrangian method. The gas phase is considered as a continuous medium and calculated by the Eulerian model, while the solid particles are considered as a discrete phase and tracked via the Lagrangian method. The reliability of the model is well verified through various field measurements and observations. Results shows that the key parameters are non-uniformly distributed along the grate width, i.e., the aerodynamic and combustion environment is poor at the vicinity of water-cooled walls compared with that at the furnace center. This results in a significant lag in volatile gases release and char oxidation near the water-cooled wall on both sides, which finally causes obvious differences in the distribution of temperature and species. For instance, the peak of CO concentration at the center is 12.6% at 3.3m from the feed entrance, while that near the water-cooled wall is 8.6% around 3.5m. The char burnout ratio in the bottom ash can be accurately calculated by this model, with a negligible relative error between the simulation of 81.97% and the measurement of 82.50%. It also provides a novel method for the calculation of fly ash particles by using size-grouped and non-spherical particles. Small-size particles in the vicinity of the feed inlet, as well as a part of the particles burning at the end of the grate are entrained into the freeboard by the primary air supplied beneath the grate and the high-momentum secondary air on the bed top. This model can provide valuable theoretical guidance for optimizing the refined distribution of fuel and air in grate-fired power plants and mitigating irregular deposition (corrosion) on heat exchangers and water-cooled walls caused by fly ash.

CFD Based Ash Deposition Prediction in a BFBC Firing Mixtures of Peat and Forest Residue

CFD Modelling of the Co-Gasification of Biomass and Coal Particles in Fluidised Beds

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

Prediction of Ash Deposition in a Biomass Boiler Using Thermomechanical Analysis

A Hybrid Method for Prediction of Ash Fouling on Heat Transfer Surfaces

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

A Hybrid Prediction Approach for Enhancing Heat Transfer Efficiency of Coal-Fired Power Plant Boiler

Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

Measurements and Prediction of Ash Deposition in a Cyclone-Fired Boiler Operating under Variable Load Conditions

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis

Detection of onset of agglomeration in a bubbling fluidized bed biomass combustor using reactive Eulerian computational fluid dynamics

Semi-empirical Technique for Predicting Ash Size Distribution in CFB Boilers

Heat Transfer Efficiency Prediction of Coal-Fired Power Plant Boiler Based on CEEMDAN-NAR Considering Ash Fouling

Modelling of Fly Ash Viscous Deposition and Slagging Prediction of Biomass-fired Boiler

Modeling and Prediction of Biomass Direct Fired Circulating Fluidized Bed Boiler Combustion System

A six-parameter model to predict ash formation in a CFB boiler

CFD simulation study of a biomass pellet-fuelled boiler

Numerical Modelling of the Co-Firing of Pulverised Coal and Straw in A 300 Mwe Tangentially Fired Boiler

An Integrated Model for Flexible Simulation of Biomass Combustion in a Travelling Grate-Fired Boiler