Mechanical behaviour of a novel floor system with horizontal K-shaped brace in Long-span High-speed railway steel truss Cable-stayed bridge

Zhou Shi,Wanqing Yu,Jiachang Gu,Jiaqi Li,Meiling Zhong

DOI: https://doi.org/10.1016/j.engstruct.2021.113270

IF: 5.582

2021-12-01

Engineering Structures

Abstract:In this study, a novel floor system with horizontal K-shaped braces was applied to long-span high-speed railway steel truss cable-stayed bridges to reduce the crossbeams' out-plane bending moment which is significant in the traditional stringer-crossbeam floor system. Based on the new floor system of Beijiang Bridge, a 1:4 scaled floor system specimen was experimentally tested; subsequently, two detailed finite element (FE) models for comparison of the specimen were established to investigate the stress distributions, force transferring and deformation characteristics. Furthermore, the ratio formula of the longitudinal force transmitted by the K-braces to that by crossbeam was determined. The results of the comparative analysis of FE models indicate that the horizontal K-shaped brace can reduce 81.0% of the crossbeam's maximum stress caused by the out-plane bending moment and alleviate the longitudinal deformations. The measured stresses of the model increased linearly with the applied load from 0.4 to 2.2 times the maximum tension force cases. The K-shaped brace mainly bears axial force; additionally, the out plane bending moment of the crossbeam is small. The longitudinal force transmission ratio is determined by the geometric parameters of the floor system structure, such as section area Ak of the K-shaped brace, and the distance between the side stringer and the lower chord Lc (rather than load type or value). The longitudinal force transmission ratio calculated by experimental and numerical stresses were in the ranges of 1.35 to 6.46 and 1.39 to 7.30, respectively. This indicates that the horizontal K-shaped brace transmits 57.45 to 86.60 % and 58.16 to 87.95 % of the longitudinal force, for experimental and normal stresses, respectively. The similar ratio ranges in both cases reveal that the K-shaped brace can effectively transfer longitudinal forces, reduce the out-plane moment of the crossbeam, and improve the mechanical characteristic of the floor system.