Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Proposal of Vibration Control Reducing 2nd Radial Electromagnetic Force

Negative Sequence Current Suppression of Dual Three-Phase Permanent Magnet Synchronous Machines Considering Inductance Asymmetry

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Researches on Behavior of Vibration in Axial Flux Permanent Magnet Synchronous Motor

Research on Radial Vibration Model and Low-Frequency Vibration Suppression Method in PMSM by Injecting Multiple Symmetric Harmonic Currents

A novel control strategy for vibration reduction in the permanent magnet motor drive system with eccentric load

Techniques to restrain harmonics of dual three-phase permanent magnet synchronous motor

Vibration Suppression for Magnetically Levitated High-Speed Motors Based on Polarity Switching Tracking Filter and Disturbance Observer

A Comprehensive Investigation of Tangential Force and Radial Force in PM Motor

Finite Element Analysis of Electromagnetic Force in Doubly-Salient Motor

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Reduction of Sixth-order Radial Force by Harmonic Current Control and Its Application to EPS Motors

Analytical modeling of stator vibration for surface mount permanent magnet brushless motors

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Vibration Contribution Analysis of Radial and Tangential Electromagnetic Force Harmonic of Permanent Magnet Synchronous Motor

Reduction of Vibration and Noise in Low Speed Direct-driven PMSMs

Active Vibration Control via Current Injection in Electric Motors

Vibration Enhancement or Weakening Effect Caused by Permanent Magnet Synchronous Motor Radial and Tangential Force Formed by Tooth Harmonics

Analysis And Design Of A Maglev Permanent Magnet Synchronous Linear Motor To Reduce Additional Torque In Dq Current Control