Abstract:Gold catalysts supported on titania (Au-TiO(2)) and alumina (Au-Al(2)O(3)) were prepared by deposition-precipitation with urea and then activated before characterisation and reaction in CO oxidation, either by calcination in air at 500 °C or reduction under H(2) at 300 °C. Gold nanoparticles with average size in the range 2-4 nm were obtained, with calcination leading to larger gold nanoparticles than reduction. For Au-TiO(2), high activity was observed in CO oxidation at room temperature, independent of the activation treatment. This high activity could not be correlated to the presence of sub-nanometer gold clusters as reported in the literature, since they could not be detected by atomic-resolution high-angle annular dark-field scanning-transmission electron microscopy (HAADF-STEM). In the case of Au-Al(2)O(3), the performance in CO oxidation was found to strongly depend on the water content in the reaction gas feed and on the activation conditions, with calcination resulting in a poorly active catalyst whereas reduction gave activity of the same order as Au-TiO(2). A comparative study of Au-TiO(2) and Au-Al(2)O(3) by electron microscopy did not reveal distinct differences in the shapes of the Au nanoparticles, which are mostly flattened through interaction with the substrate in both samples, with side profile shapes varying from rounded hemispherical to well faceted truncated cubo-octahedra. More faceting is found for the samples calcined at 500 °C than reduced at 300 °C. Various possible parameters affecting the catalytic properties of gold in CO oxidation are discussed in the context of the relevant literature.

Catalytic oxidation of carbon monoxide over of gold-supported iron oxide catalyst

Improved Catalytic Performance of Au/α-Fe2O3-Like-Worm Catalyst for Low Temperature CO Oxidation

Catalytic behavior of gold nanoparticles supported on a TiO2-Al2O3 mixed oxide for CO oxidation at low temperature

HRTEM and STEM-HAADF characterisation of Au-TiO2 and Au-Al2O3 catalysts for a better understanding of the parameters influencing their properties in CO oxidation

Low Temperature CO Oxidation Over Highly Active Gold Nanoparticles Supported on Reduced Graphene Oxide@Mg-BTC Nanocomposite

Gold Nanoparticles on Electroless-Deposition-derived MnOx/C: Synthesis, Characterization, and Catalytic CO Oxidation

Novel Au/TiO 2 /al 2 O 3 · X H 2 O Catalysts for CO Oxidation

Low-temperature oxidation of carbon monoxide with gold(III) ions supported on titanium oxide

Gold Nanoparticles Deposited on Manganese(iii) Oxide As Novel Efficient Catalyst for Low Temperature CO Oxidation

Influence of hematite morphology on the CO oxidation performance of Au/α-Fe2O3

The Catalytic Performance of Isolated-Dispersed Au on Nanosized CeO2 for CO Preferential Oxidation in H2-rich Stream

Highly Efficient Nano-octahedral Au/γ-Fe2O3 Catalyst Synthesized by Dealloying Combined with Calcination for Low-Temperature CO Oxidation

Gold nanoparticles supported on manganese oxides for low-temperature CO oxidation

Effect Ofmesoporous Supports on Gold Nanoparticles Activity in Toluene Oxidation

Heterostructured Catalysts Prepared by Dispersing Au@Fe2O3 Core–shell Structures on Supports and Their Performance in CO Oxidation

Catalytic properties of supported gold nanoparticles: new insights into the size-activity relationship gained from in operando measurements.

Morphology effects of nanoscale ceria on the activity of Au/CeO2 catalysts for low-temperature CO oxidation

Gold Nanoparticles Supported on Hydroxylapatite As High Performance Catalysts for Low Temperature CO Oxidation

The rod-like CeO2 supported by the low-loading Au nanoparticles for the efficient catalytic oxidation of CO at room temperature

Catalytic Role of Metal Oxides in Gold-Based Catalysts: A First Principles Study of CO Oxidation Ontio2supported Au

Effect of Ni Addition on the Low Temperature Carbon Monoxide Oxidation over Au/HAP Nanocatalyst