Abstract:Gold catalysts supported on titania (Au-TiO(2)) and alumina (Au-Al(2)O(3)) were prepared by deposition-precipitation with urea and then activated before characterisation and reaction in CO oxidation, either by calcination in air at 500 °C or reduction under H(2) at 300 °C. Gold nanoparticles with average size in the range 2-4 nm were obtained, with calcination leading to larger gold nanoparticles than reduction. For Au-TiO(2), high activity was observed in CO oxidation at room temperature, independent of the activation treatment. This high activity could not be correlated to the presence of sub-nanometer gold clusters as reported in the literature, since they could not be detected by atomic-resolution high-angle annular dark-field scanning-transmission electron microscopy (HAADF-STEM). In the case of Au-Al(2)O(3), the performance in CO oxidation was found to strongly depend on the water content in the reaction gas feed and on the activation conditions, with calcination resulting in a poorly active catalyst whereas reduction gave activity of the same order as Au-TiO(2). A comparative study of Au-TiO(2) and Au-Al(2)O(3) by electron microscopy did not reveal distinct differences in the shapes of the Au nanoparticles, which are mostly flattened through interaction with the substrate in both samples, with side profile shapes varying from rounded hemispherical to well faceted truncated cubo-octahedra. More faceting is found for the samples calcined at 500 °C than reduced at 300 °C. Various possible parameters affecting the catalytic properties of gold in CO oxidation are discussed in the context of the relevant literature.

Effect Ofmesoporous Supports on Gold Nanoparticles Activity in Toluene Oxidation

Study of Cyclohexane Oxidation over Au/Al_2O_3 Catalyst

Gold catalysts supported on cerium-modified mesoporous zirconia for total toluene oxidation. Effect of Ce/Zr molar ratio

Toluene catalytic oxidation over gold catalysts supported on cerium-based high-entropy oxides

Catalytic oxidation of carbon monoxide over of gold-supported iron oxide catalyst

Catalytic behavior of gold nanoparticles supported on a TiO2-Al2O3 mixed oxide for CO oxidation at low temperature

Insights into CO oxidation on Au/TiO2-HMor zeolite catalysts at low temperature

HRTEM and STEM-HAADF characterisation of Au-TiO2 and Au-Al2O3 catalysts for a better understanding of the parameters influencing their properties in CO oxidation

Au/MxOy/TiO2 Catalysts for CO Oxidation: Promotional Effect of Main-Group, Transition, and Rare-Earth Metal Oxide Additives

Gold Nanoparticles Supported on Mesoporous Silica and Their Catalytic Application

Catalytic properties of supported gold nanoparticles: new insights into the size-activity relationship gained from in operando measurements.

The Preparation of Stable TiO2 Nanotubes Supported Gold Catalysts and Their Catalytic Performance for CO Oxidation

High-Surface-Area Mesoporous Crystalline TiO2: Synthesis, Characterization, and Application As Support for Making Stable Au Catalysts

Change of the surface species on Au/CeO2-TiO2 during in the reduction and CO oxidation

Morphology effects of nanoscale ceria on the activity of Au/CeO2 catalysts for low-temperature CO oxidation

Catalytic Oxidation Of Toluene With Low Loading Bimetallic Au@Pt Core-Shell Catalyst

Effect of Gold Electronic State on the Catalytic Performance of Nano Gold Catalysts in n-Octanol Oxidation

Low Temperature CO Oxidation Over Highly Active Gold Nanoparticles Supported on Reduced Graphene Oxide@Mg-BTC Nanocomposite

Influence of Cerium Modification Methods on Catalytic Performance of Au/mordenite Catalysts in CO Oxidation

The Catalytic Performance of Isolated-Dispersed Au on Nanosized CeO2 for CO Preferential Oxidation in H2-rich Stream

Operando Raman-online FTIR Investigation of Ceria, Vanadia/ceria and Gold/ceria Catalysts for Toluene Elimination