Abstract:A photonic lantern is a low-loss device that connects a single multimode waveguide to multiple single-mode waveguides and can enhance the beam quality of a fiber laser by adaptively controlling the optical parameters (amplitude, phase, polarization) at the input. In this work, we combined the gains and losses of individual modes within the fiber amplifier and introduced a mode content parameter at the amplifier's output as an evaluation function to simulate mode control effects. Mode competition within the gain fiber can degrade the control effect of the fundamental mode and lead to it taking a longer time for the control to converge. Optimal parameters, such as the gain fiber length and pumping method, were identified to improve control effectiveness. Specifically, an optimal gain fiber length of 8 m was determined, and backward pumping was found to achieve higher pumping efficiency and better control results. The system demonstrated significant power amplification potential and could stabilize mode control under different pumping powers ranging from 50 W to 5 kW. In conclusion, our research demonstrates that an adaptive fiber amplifier based on a photonic lantern can achieve a stable, high-power, large-mode-field, near-fundamental-mode output from the gain fiber. Although mode competition within the gain fiber can degrade the control effect of the fundamental mode and cause the control to take a longer time to converge, these aspects should be further studied to improve the control's effectiveness. These findings contribute to the development of advanced simulation models that guide high-power mode control experiments and deepen our understanding of physical processes in science and technology.

Mitigating mode instabilities by controllable mode beating excitation with a photonic lantern

Mitigating transverse mode instability in fiber laser oscillator by employing direct pump modulation

Transverse mode instability mitigation in high-power confined-doped fiber amplifier with good beam quality through seed laser control

Mitigation of transverse mode instability in polarization maintaining, high-power fiber amplifiers

The Simulation of Mode Control for a Photonic Lantern Adaptive Amplifier

Experimental study of the influence of mode excitation on mode instability in high power fiber amplifier

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

High-Power Orbital Angular Momentum Beam Generation Using Adaptive Control System Based on Mode Selective Photonic Lantern

Realizing a kilowatt-level fiber amplifier with a 42 μm core diameter fiber for improved multi-mode performance towards single mode operation output through adaptive spatial mode control utilizing a 3×1 photonic lantern

Effective mitigation of photodarkening-induced transverse mode instability in a monolithic fiber laser oscillator by 450?nm laser irradiation

Comparison and Optimization on Transverse Mode Instability of Fiber Laser Amplifier Pumped by Wavelength-Stabilized and Non-Wavelength-Stabilized 976 Nm Laser Diode

Optimal input excitations for suppressing nonlinear instabilities in multimode fibers

Dynamic modal characteristics of transverse mode instabilities in ytterbium-doped fiber laser oscillator

Low-threshold mode instability in few-mode Yb3+-doped fiber amplifiers: an overview of recent results

Optimizing the pump wavelength to improve the transverse mode instability threshold of fiber laser by 3.45 times

Influence of Pump Current Waveform on The Mitigation of Transverse Mode Instability in Fiber Laser Oscillator

Theoretical Study on Transverse Mode Instability in Raman Fiber Amplifiers Considering Mode Excitation

Impact of gamma-ray radiation-induced photodarkening on mode instability degradation of an ytterbium-doped fiber amplifier

Accurate Modeling of Transverse Mode Instability in Fiber Amplifiers

Experimental Investigation of Quasi-Static Mode Degradation in a High Power Large Mode Area Fiber Amplifier.

Increasing Mode Instability Threshold by Mitigating Driver Noise in High Power Fiber Amplifiers