Abstract:<p>A 1.7 μm Tm-doped continue-wave and pulse fiber laser based on variable pulse generated mechanisms is proposed and experimentally demonstrated. The modulated pump was used to generate pulses in the cavity by switching mechanisms easily (gain-switched, self-saturable absorber and active mode-locking via pump modulation (AMPM)). In the laser scheme, a 1.55 μm amplified optically modulated signal generator was used as a homemade pump, including a semiconductor laser, a pulse signal driver and an erbium-doped fiber amplifier (EDFA). A 3-m long thulium-doped fiber (TDF) was pumped to obtained gain which covered 1.7 µm band. A Fiber Bragg Grating (FBG) is employed as a spectrum filter. Using the proposed scheme, we achieved the laser with a central wavelength of 1727.92 nm. The laser had a high Side-Mode Suppression Ratio (SMSR) of 59 dB and a 3 dB linewidth of 0.18 nm. Additionally, we modulated the pump, and the pulse train with a repetition rate from 10 kHz to100 kHz based on gain-switched mechanism was obtained. Aim to increase the repetition rate, the generation of self-mode-locked pulses with a repetition rate of 11.39 MHz was observed associating with a self-saturable absorber using a CW pump. Moreover, We adjusted the modulated frequency of pump to match with the free spectral range of the cavity, the pulse train with repetition rate of 11.39 MHz was obtained with higher signal power based on AMPM, and the serval order harmonic mode-locking states with repetition rate from 22.78 MHz to 45.56 MHz were demonstrated with the appropriate pump frequency.</p>

Optimizing the pump wavelength to improve the transverse mode instability threshold of fiber laser by 3.45 times

Comparison and Optimization on Transverse Mode Instability of Fiber Laser Amplifier Pumped by Wavelength-Stabilized and Non-Wavelength-Stabilized 976 Nm Laser Diode

Mitigating transverse mode instability in fiber laser oscillator by employing direct pump modulation

Influence of Pump Current Waveform on The Mitigation of Transverse Mode Instability in Fiber Laser Oscillator

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

Nonlinearity Optimization of Dissipative-Soliton Fiber Laser for Generation of Pulses with 350 Kw Peak Power

Dynamic modal characteristics of transverse mode instabilities in ytterbium-doped fiber laser oscillator

Effective mitigation of photodarkening-induced transverse mode instability in a monolithic fiber laser oscillator by 450?nm laser irradiation

1.7 µm gain-switched and mode-locked hybrid Tm-Ho codoped fiber laser signal generation and optimization

A 4.8-kW high-efficiency 1050-nm monolithic fiber laser amplifier employing a pump-sharing structure

Synchronously Pumped Mode-Locked 1.89 μm Tm-Doped Fiber Laser with High Detuning Toleration

The effect of population inversion saturation on the transverse mode instability threshold in high power fiber laser oscillators

1.7 μm Tm-doped continue-wave and pulse fibre laser using a modulated pump based on variable pulse generated mechanisms

Optimization and demonstration of 6 kW oscillating-amplifying integrated fiber laser employing spindle-shaped fiber to suppress SRS and TMI

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

Theoretical and experimental analysis of instability of continuous wave mode locking: Towards high fundamental repetition rate in Tm<sup>3+</sup>-doped fiber lasers.

Theoretical and Experimental Analysis of Instability of Continuous Wave Mode Locking: Towards High Fundamental Repetition Rate in Tm^3+-doped Fiber Lasers

Kilowatt-Level High-Efficiency Narrow-Linewidth All-Fiber Tm3+-Doped Laser

A 5 kW Nearly-Single-Mode Monolithic Fiber Laser Emitting at ~1050 nm Employing Asymmetric Bi-Tapered Ytterbium-Doped Fiber

Experimental Study on Transverse Mode Instability Characteristics of Few-Mode Fiber Laser Amplifier Under Different Bending Conditions

High-speed modal analysis of dynamic modal coupling in fiber laser oscillator