Abstract:The influencing characteristic for the evolution mechanism of a dynamic stall vortex structure and distributed blowing control on rotor airfoils was investigated. Based on the moving-embedded grid method, the finite volume scheme, and Roe's FDS scheme, a simulation method for the unsteady flow field of a pitch-oscillating airfoil was established. The flow field of the NACA63-218 airfoil was calculated using Reynolds-averaged Navier–Stokes equations. The evolution processes of different vortex structures during dynamic stall and the principal controlled vortex mechanism affecting aerodynamic nonlinearity were analyzed based on the pressure contours Cp and Q of the flow field structure and the spatiotemporal evolution characteristics of the wall pressure distribution. The research indicated that dynamic stall vortices (DSVs) and shear layer vortices (SLVs) were the major sources of the increase in aerodynamic coefficients and the onset of nonlinear hysteresis. Building upon these findings, the concept of distributed blowing control for DSVs and shear layer vortices (SLVs) was introduced. A comparative analysis was conducted to assess the control effectiveness of dynamic stall with different blowing locations and blowing coefficients. The results indicated that distributed blowing control effectively inhibited the formation of DSVs and reduced the intensity of SLVs. This led to a significant decrease in the peak values of the drag and pitch moment coefficients and the disappearance of secondary peaks in the aerodynamic coefficients. Furthermore, an optimal blowing coefficient existed. When the suction coefficient Cμ exceeded 0.03, the effectiveness of the blowing control no longer showed a significant improvement. Finally, with a specific focus on the crucial motion parameters in dynamic stall, the characteristics of dynamic stall controlled by air blowing were investigated. The results showed that distributed air blowing control significantly reduced the peak pitching moment coefficient and drag coefficient. The peak pitching moment coefficient was reduced by 72%, the peak drag coefficient was reduced by 70%, and the lift coefficient hysteresis loop area decreased by 46%. Distributed blowing jet control effectively suppressed the dynamic stall characteristics of the airfoil, making the unsteady load changes gentler.

Passive Flow Control of Dynamically Stalled Airfoil Using a Microcylinder

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Experimental and Numerical Studies on Aerodynamic Control of NACA 4418 Airfoil with a Rotating Cylinder

Passive control of dynamic stall using a flow-driven micro-cavity actuator

Numerical Investigation on the Evolution Process of Different Vortex Structures and Distributed Blowing Control for Dynamic Stall Suppression of Rotor Airfoils

Comparative study of two combined blowing and suction flow control methods on pitching airfoils

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Numerical simulation of dynamic stall flow control using a multi-dielectric barrier discharge plasma actuation strategy

Analysis of Dynamic Stall Control on a Pitching Airfoil Using Dynamic Mode Decomposition

A Review of Flow Control Strategies for Supersonic/Hypersonic Fluid Dynamics

An efficient flow control technique based on co-flow jet and multi-stage slot circulation control applied to a supercritical airfoil

Effects of Leading-Edge Blowing Control and Reduced Frequency on Aerofoil Aerodynamic Performances

Active Flow Control of the Dynamic Wake Behind a Square Cylinder Using Combined Jets at the Front and Rear Stagnation Points

Stall control on the wind turbine airfoil via the single and dual-channel of combining bowing and suction technique

Machine learning-based optimization of a pitching airfoil performance in dynamic stall conditions using a suction controller

Dynamic kirigami structures for wake flow control behind a circular cylinder

Quantitative Study on the Flow Control of a 1:2 Rectangular Cylinder Based on the Leading-Edge Suction

Dynamic Stall Control on a Vertical Axis Wind Turbine Aerofoil Using Leading-Edge Rod

Passive Jet Approach to Control the Flow over a Circular Cylinder

Numerical study on passive-jet flow control for chamfered square cylinder

SOME DYNAMIC STALL PROPERTIES OF AN OSCILLATING CIRCULATION CONTROL AIRFOIL