Abstract:The strength of prestressed steel strands has developed towards high strength, increasing from 1860 MPa to over 2200 MPa. The stress in the prestressed anchorage zone is more concentrated and complex, and the anchor plates for dispersed loads need to be optimized in design. This article proposes a design scheme for adding a middle pressure-bearing step based on the existing anchor plate and then establishes a 1/4 model of the concrete anchoring area of the anchor plate for finite element analysis. Based on the theory of the strut-and-tie model, the position of the middle pressure-bearing step is determined according to the maximum angle of the strut-and-tie model. Then, carry out force transfer tests in the anchorage zone for verification. The research results indicate that after adding a middle pressure bearing step to the anchor plate, the angle between the strut-and-tie model in the anchorage zone increases, and the bearing capacity improves. The position of the middle pressure-bearing step in the anchor plate is different, and the angle between the strut-and-tie models is different. According to the middle step position parameter, λ (the ratio of the effective width of the middle step to the distance from the middle step to the end face of the anchor plate) is 0.533 to optimize the anchor plate, and the bearing capacity of its anchorage zone is relatively high. The main tensile and main compressive stresses of the anchor plate after optimization increased by 6.2% and 5.74%, respectively, compared to the anchor plate before optimization. The main tensile stress of the spiral reinforcement under the anchor plate decreased by 0.59%, the main compressive stress decreased by 2.89%, and the von-Mises stress decreased by 2.32%. The side surface tensile stress of concrete under the anchor plate was reduced by 4.3 percent. Finally, three concrete specimens were poured for force transfer testing in the anchorage zone, verifying the safety and reliability of the optimized anchor plate in the 2200 MPa-level prestressed anchorage zone.

Pull-out behavior of the pre-installed lifting anchor with supplementary reinforcement for the precast concrete segments of wind turbine hybrid towers

The Installation Behavior and Capacity of Piggy-Backed Anchors for Offshore Wind Turbine

Design method of prestressed anchor bolt system for wind turbine foundation

Reinforced Concrete Wind Turbine Towers: Damage Mode and Model Testing

Bearing Performance of a Novel Caisson-Plate Gravity Anchor

Field Experimental Study on Cyclic Uplift Behavior of Anchored Pier Foundations

Mechanical behavior of prestressed UHPC wind turbine tower columns under combined axial compression and bending

Crack propagation, failure and ultimate load capacity of the grout layer in the prestressed anchor bolt foundation of wind turbine tower

Pull-Out Performance of Anchored Carbon-Fiber Bundles in Cementitious Matrix

Optimized Design of Anchor Plates for 2200 MPa-Class Prestressing Anchorage Zones

Damage evolution and failure analysis of the advanced transition segment behavior of wind turbine tower

Calculation Method of Uplift Capacity of Pile-Anchor Composite Foundation and Influence of Parameters

Pullout Response of Ultra-High-Performance Concrete with Twisted Steel Fibers

Experimental and numerical study of large high strength bolt shear connector embedded in HFRC

Novel Strengthening Method of Signal Tower Using Prestressed CFRP Plates: Concept and Behavior

Coupled behaviour and strength prediction of tapered CFDST columns with large hollow ratios for wind turbine towers

Numerical Simulation of Offshore Monopiles with Reinforcement in Shallow Soil Layer

Anchorage failure mechanism and uplift bearing capacity of L- & J-anchor bolts in plain concrete

Pull-out Model Test for Tunnel Anchorage and Numerical Analysis

3D Analysis of Anchor Bolt Pullout in Concrete Materials Using the Non-Ordinary State-Based Peridynamics

BUCKLING BEHAVIOUR OF THE STEEL PLATE IN STEEL – CONCRETE – STEEL SANDWICH COMPOSITE TOWER FOR WIND TURBINE