Abstract:Background: As the use of all-suture anchors continues to increase, limited biomechanical data on the use of these anchors in various configurations for tenodesis of the long head biceps tendon (LHBT) exists. The aim of this study was to compare the biomechanical properties of a 2-anchor luggage tag suprapectoral biceps tenodesis (Sup-BT) vs. a single-anchor whipstitch subpectoral biceps tenodesis (Sub-BT) using all-suture anchors. The hypothesis was that the Sub-BT will have a higher ultimate load to failure and less creep relative to the Sup-BT construct. Methods: Eighteen fresh frozen cadaveric humeri were used. The specimens were randomly divided into 2 groups of 9; i) The Sup-BT were performed with 2 1.8 mm knotless all-suture anchors using a luggage-tag fixation configuration, ii) The Sub-BT were performed using a single 1.9 mm all-suture anchor and a whipstitch suture configuration with a tied knot. The humeri were tested on a hydraulic MTS machine where the specimens were preloaded at 5 N for 2 minutes and then cyclically loaded from 5 to 50 N for 1000 cycles at 1 Hz while maximum displacement was recorded with a motion system and markers attached to the bone and bicep tendon. The tendon was then tensioned at a rate of 1 mm/s to obtain the ultimate load to failure. CT scans of the specimens were used to calculate the bone mineral density at the site of the anchor/bone interface and video recordings were captured during load to failure to document all modes of failure. Results: There was no significant difference in the average load to failure of the Sup-BT and Sub-BT groups (197 N ± 45 N (SD), 164 N ± 68 N (SD) respectively; P = .122) or creep under fatigue between the Sup-BT vs. Sub-BT specimens (3.1 mm, SD = 1.5 vs. 2.2 mm, SD = 0.9; P = .162). The bone mineral density was statistically different between the 2 groups (P < .001); however, there were no observed failures at the anchor/bone interface and no correlation between failure load and bone mineral density. Conclusion: The ultimate load to failure and creep between a Sup-BT with 2 knotless all-suture anchors using a luggage tag suture configuration was equivalent to a Sub-BT with 1 all-suture anchor using a whipstitched suture configuration and a tied knot. Surgeons can perform either technique confidently knowing that they are biomechanically equivalent in a cadaver model at time zero, and they offer similar strength to other fixation methods cited in the literature.

Biomechanical evaluation of double-stranded knot configurations in high-strength sutures and tapes

A Steered Molecular Dynamics Study on the Elastic Behaviour of Knotted Polymer Chains

The effect of number of knots per throw, knot technique, and suture type on strength properties of suspensory fixation button surgical procedures

Biomechanical Evaluation of Cranial Flap Fixation Techniques: Comparative Experimental Study of Suture, Stainless Steel Wire, and Rivetlike Titanium Clamp

Effect of structural parameters, knotting methods, and wet state on the tensile properties of sutures for orthopedic surgery

Can a Two Simple Stitches Method Provide Secure Fixation Strength in Biceps Tenodesis?: Biomechanical Evaluation of Various Suture Techniques

New dynamic suture material for tendon transfer surgeries in the upper extremity – a biomechanical comparative analysis

Self-Tensioning Feature of Knotless Suture Anchor Provides Reproducible Knotless Fixation Independent of Initial Tension

Mechanical Analysis of a Novel Sternal Closure System in Static Tensile Loading

Stapled fascial suture: ex vivo modeling and clinical implications

Biomechanical Evaluation of Transverse Patella Fracture Fixation Using Headless Screws: A Comparison of Suture Versus Cable as a Tension Band

Towards A Better Knot: Using Mechanics Methods to Evaluate Three Knot-Tying Techniques in Laparo-Endoscopic Single-Site Surgery

Biomechanical and histological comparison of two suture configurations for soft tissue grafts: speedtrapTM versus krackow stitch

Assessment of the Mechanical Properties of Different Suture Materials for Oral Surgery: An In Vitro Tensile Strength Study

The effect of the number of strands and knot throws of core suture techniques on the mechanical properties of the repaired flexor tendon

A Symmetric Anchor Designed Barbed Suture Versus Conventional Interrupted Sutures In Total Knee Arthroplasty: A Multicenter, Randomized Controlled Trial

Low incidence of adverse events or construct failure of a novel high-strength No.2 round suture in rotator cuff repair: An IDEAL Stage 2a assessment retrospective cohort analysis

Biomechanical properties of suprapectoral biceps tenodesis with double-anchor knotless luggage tag sutures vs. subpectoral biceps tenodesis with single-anchor whipstitch suture using all-suture anchors

Mechanical fabrication and evaluation of bioresorbable barbed sutures with different barb geometries

Comparison of Strength, Consistency, and Speed of COR-KNOT versus Manually Hand-Tied Knots in an Ex Vivo Minimally Invasive Model

Study of dural suture watertightness: an in vitro comparison of different sealants