Abstract:The heating problems in electronic devices have become even more significant with the development of technology and the rapid increase in areas of use. In cases where passive cooling and active cooling processes are not sufficient to improve overheating in electronic devices, high temperature generation is prevented by liquid cooling if convenient. The effect of nanofluid use on heat transfer to improve the thermal performance of liquid cooling systems was examined with computational fluid dynamics from numerical methods in this research. For different cooler designs, both single‐phase and multiphase modeling methods were utilized in fluid modeling in the research involving forced convection and heat transfer in laminar and turbulent flow. The mathematical models utilized were validated on different experimental and numerical researches. The single‐phase modeling was conducted for pure H2O, 1% Al2O3, 5% Al2O3 nanofluids at different Reynolds numbers. The analyzes were conducted at different Reynolds values and the increase in Reynolds value decreases the maximum temperature value at the output. In the multiphase modeling method, the nanofluid Al2O3 is defined and modelled as a separate phase suspended in different sizes into the base fluid H2O. The use of nanofluid increased the thermal conductivity in both methods compared to the use of pure H2O. At the same time, the use of nanofluids at 5% concentration gave better results than 1% concentration. As the temperature distributions are examined, the Mixture model, one of the single‐phase and multiphase modeling methods, presents very similar distributions. The effect of nanofluids on thermal performance varies depending on many parameters. A significant one is the size of the suspended nanoparticle. Different particle sizes, 20, 30, and 40 nm, were investigated in both Mixture and Eulerian modeling approaches in this research. Two different design coolers were utilized in the researches. In these designs, the flow is distributed in parallel and serpentine. The flow distribution and pressure drop also had an effect on thermal performance. The temperatures were read lower in the serpentine block, which provides a more regular flow distribution.

Cooling electronic components by using nanofluids: a review

An Updated Review on Improving Radiator Efficiency Using Nanofluid Coolants

Solar radiation and heat sink impact on fluctuating mixed convective flow and heat rate of Darcian nanofluid: Applications in electronic cooling systems

Numerical Investigation of Nanofluid as a Coolant in a Prismatic Battery for Thermal Management Systems

A review on nanofluid: preparation, stability, thermophysical properties, heat transfer characteristics and application

An Assessment of Effects of Nanofluids on Heat Transfer Performance of Two-Phase Cooling Systems

Nanofluids in microchannel heat sinks for efficient flow cooling of power electronic devices

A critical insight on nanofluids for heat transfer enhancement

Application of Nanofluids in Gas Turbine and Intercoolers-A Comprehensive Review

Nanofluid: Potential evaluation in automotive radiator

Design of single and two phase modeled nanofluid CPU cooler and their numerical analysis

A Review of Nanofluids as Coolants for Thermal Management Systems in Fuel Cell Vehicles

Analytical and Experimental Study of Nano Particles Effect in Engine Cooling System

Effects of Nanofluid Flow in Micro channel Heat Sink for Forced Convection Cooling of Electronics Device: A Numerical Simulation

Review on Nanofluids: Preparation, Properties, Stability, and Thermal Performance Augmentation in Heat Transfer Applications

Study the Convective Heat Transfer Intensification by Using Nanotechnology: A Review

An Experimental Study on the Effect of Nanofluids on the Thermal Conductivity and Rheological Properties of a Coolant for Liquids

Thermal and hydraulic characteristics of a single reverse nanofluid jet in a double-wall cooling configuration

Impact of surfactant on Al 2 O 3 /water nanofluids stability for cooling the central processing unit of computer

Recent advances of nanofluids in micro/nano scale energy transportation

Enhancing radiator cooling capacity: A comparative study of nanofluids and water/EG mixtures