Abstract:To investigate the variation laws of various hydraulic parameters and internal fluid flow patterns of eccentric semi-ball valves under different boundary conditions, the DPM model was used to numerically simulate the eccentric semi-ball valve based on Fluent 2021 R1 software. The flow velocity, pressure distribution, and erosion wear rate on the valve wall were simulated under different combinations of opening, inlet flow velocity, and sediment concentration conditions, and hydraulic parameters such as drag coefficient, flow coefficient, and cavitation coefficient were calculated. The results show that as the opening of the eccentric semi-ball valve increases, the valve drag coefficient decreases, the flow coefficient increases, the cavitation coefficient increases, and the degree of cavitation decreases. The flow velocity in the high-velocity zone at both ends of the valve plate decreases, and the gradient of water flow velocity passing through the valve decreases. The area of the low-velocity zone at the rear of the valve plate decreases, and the vortex phenomenon gradually weakens; as the sediment content in the water increases, the valve drag coefficient increases, the flow coefficient decreases, and the cavitation coefficient first increases and then decreases. The maximum flow velocity of the pipeline decreases faster and faster, causing an increase in pressure gradient in the flow area and drastic changes. This results in higher pressure on the pipe wall near the valve plate, especially a significant increase in negative pressure; As the inlet flow rate increases, the valve drag coefficient decreases, the flow coefficient increases, and the cavitation coefficient gradually decreases. The flow velocity of the water passing through the valve increases, and the low-pressure area downstream of the valve plate increases. The pressure gradient at both ends of the valve port increases significantly from small to large, and the positive pressure upstream of the valve plate gradually increases. The force of the water flow on the valve plate is large, causing friction between the valve stem and the valve body, which is not conducive to long-term operation. With the increase in inlet flow rate, the maximum wear amount and wear range of the valve plate have significantly increased, and erosion wear is mainly distributed in point blocks at the edge of the valve plate. This study can provide certain references and solutions for the key technology research of eccentric semi-ball valves and assess the performance indicators of the operation being maintained.

Increasing energy efficiency and flow coefficient by determining fluid behaviours with computer aided design and CFD analysis in isolation valves

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Computational design optimization of industrial single piece ball valve to enhance the flow performance

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

Planning of a Single Flow Channel in Valve Blocks Based on Additive Manufacturing and the Ant Colony Algorithm

Numerical simulation and experimental research of a new butterfly valve

Advanced Valves and Pump Coordinated Hydraulic Control Design to Simultaneously Achieve High Accuracy and High Efficiency.

Fluid Dynamics Analysis and Optimized Throttling Design of L-shaped Multi-Stage High Pressure Reducing Valve

Localized Property Design and Gradient Processing of a Hydraulic Valve Body Using Selective Laser Melting

Design Optimization of Mechanical Valves in Dishwashers Based on the Minimization of Pressure Losses

Flow Analysis of a Needle Type Throttle Valves via Experimental and Numerical Methods

An Intelligent CFD-Based Optimization System for Fluid Machinery: Automotive Electronic Pump Case Application

Design and Experimental Tests of a Four-Way Valve with the Determination of Flow Characteristics for Building Central Heating Installations Using Solid Modeling

CFD Analysis on the Dynamic Flow Characteristics of the Pilot-Control Globe Valve

Numerical Investigation And Shape Design Improvement Of A Turbine Inlet Combined Valve

Multi-objective global optimization of a butterfly valve using genetic algorithms

A novel design and performance optimization methodology for hydraulic Cross-Flow turbines using successive numerical simulations

Numerical simulation of casting process for gray iron butterfly valve

STUDYING THE HYDRAULIC CHARACTERISTICS OF UPVC BUTTERFLY VALVE BY CFD TECHNIQUE

Numerical Simulation Study on Hydraulic Characteristics and Wear of Eccentric Semi-Ball Valve under Sediment Laden Water Flow