Abstract:In the actual industrial production process, the method of adaptively tuning proportional–integral–derivative (PID) parameters online by neural network can adapt to different characteristics of different controlled objects better than the controller with PID. However, the commonly used microcontroller unit (MCU) cannot meet the application scenarios of real time and high reliability. Therefore, in this paper, a closed-loop motion control system based on BP neural network (BPNN) PID controller by using a Xilinx field programmable gate array (FPGA) solution is proposed. In the design of the controller, it is divided into several sub-modules according to the modular design idea. The forward propagation module is used to complete the forward propagation operation from the input layer to the output layer. The PID module implements the mapping of PID arithmetic to register transfer level (RTL) and is responsible for completing the output of control amount. The main state machine module generates enable signals that control the sequential execution of each sub-module. The error backpropagation and weight update module completes the update of the weights of each layer of the network. The peripheral modules of the control system are divided into two main parts. The speed measurement module completes the acquisition of the output pulse signal of the encoder and the measurement of the motor speed. The pulse width modulation (PWM) signal generation module generates PWM waves with different duty cycles to control the rotation speed of the motor. A co-simulation of Modelsim and Simulink is used to simulate and verify the system, and a test analysis is also performed on the development platform. The results show that the proposed system can realize the self-tuning of PID control parameters, and also has the characteristics of reliable performance, high real-time performance, and strong anti-interference. Compared with MCU, the convergence speed is far more than three orders of magnitude, which proves its superiority.

Using advanced FPGA SoC technologies for the design of industrial control applications

FPGAs in Industrial Control Applications

FPGA Design Methodology for Industrial Control Systems—A Review

Development of embedded fuzzy control using reconfigurable FPGA technology

FPGA-Based Optimization of Industrial Numerical Machine Tool Servo Drives

Low-Cost Embedded Controller for Complex Control Systems

FPGA-Based Cost-Effective and Resource Optimized Solution of Predictive Direct Current Control for Power Converters

Design of High-Performance Electrical Servo System Based on FPGA

FPGAs used in industrial control and instrumentation systems

Guest Editorial Special Section on Industrial Control Applications of FPGAs

Development of control algorithms for mobile robotics focused on their potential use for FPGA-based robots

Design of Digital PID Controller Based on FPGA

Optimization and Implementation of Intelligent PID Controller Based on FPGA

Industrial robot arm controller based on programmable System-on-Chip device

Design of Field Programmable Gate Array (FPGA) Based Emulators for Motor Control Applications

Optimal hardware/software partitioning of a system on chip FPGA-based sensorless AC drive current controller

Hardware Design and Implementation of Electronic Throttle Controller Based on FPGA

FPGA Realization of ANFIS Controller Using a Proposed Digital Design

A Design of FPGA-Based Neural Network PID Controller for Motion Control System

FPGA-Based Implementation of SCADA System for Fuel Management

An SoC-based Platform for Integrated Multi-Axis Motion Control and Motor Drive