Abstract:Thermal-sprayed coatings are expected to have a relatively smooth surface when used under certain service conditions, such as to improve their erosion resistance or decrease the adhesion of CMAS sands. In this study, a new method for grinding ceramic coatings was proposed that uses an industrial robot, a floating spindle, a rubber binder grinding head, and diamond plaster to automatically grind ceramic coatings on basis of free abrasive grinding. Typical 8YSZ thermal barrier coatings (TBCs) were created on nickel-based superalloy plates using atmospheric plasma spraying (APS) in order to explore the impact of such grinding on their morphology and comprehensive performance. Following the grinding with the proposed process, the coating's surface roughness, removal weight and thickness, as well as 3D surface morphology were all measured. The microstructure, wetting angle, infrared emittance, microhardness, bonding strength, particulate erosion resistance, and thermal cycling life of the as-sprayed and ground 8YSZ coatings were comparatively studied using the corresponding characterization instrument. The results show that the coating's surface roughness can be decreased to roughly 1 μm, and its removal thickness ranges between 45 and 90 μm. Besides from the wettability of the droplet on the coating's surface rises, the coating's infrared emittance, mechanical properties, thermal cycling life, and erosion resistance are not noticeably different after grinding, demonstrating that such novel grinding technique won't weaken the microstructure or shorten the coating life. It could offer guidance for the urgently required development of grinding processes for ceramic coatings with complex surfaces.

Selective Plasma Treatment Endowing Low-Friction and Wear-Resistant Surface of Polycrystalline Diamond against Copper

Tribological Properties Of Diamond-Like Carbon-Films Deposited On Silicon Using Rf Plasma-Enhanced Cvd

A comparative friction and wear study of diamond and diamond-like carbon films against Cu

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Diamond coatings on copper surfaces through interface engineering

Superlow friction and wear enabled by nanodiamond and hexagonal boron nitride on a-C:H films surfaces in dry nitrogen

Comparing the tribological behavior of polycrystalline diamonds against steel GCr15 and ceramic Si 3 N 4 : friction and wear

Microstructure and Tribological Performance of Self-Lubricating Diamond/tetrahedral Amorphous Carbon Composite Film

Achieving precise graphenization of diamond coatings below the interfacial thermal stress threshold

Friction and Wear Behavior of Duplex-Treated AISI 316L Steels by Rapid Plasma Nitriding and (crwaltisi)n Ceramic Coating

Vacuum Thermal Treatment for Achieving Macroscale Superlubricity by Nanodiamond and Hexagonal Boron Nitride on H‐DLC Film Surfaces in Dry Nitrogen

Enhancing wear resistance, hardness, and thermal conductivity of copper diamond composites through optimization strategies

Friction and wear of polycrystalline diamond in oil drilling: a review

A critical review on the chemical wear and wear suppression of diamond tools in diamond cutting of ferrous metals

Friction and wear behaviors of polycrystalline diamond self-mated pairs in air and water lubrication conditions

Research status on surface metallization of diamond

Lubrication and Anti-Wear Behavior of Duplex Annealed Nanodiamonds/peo Coating on Ti6Al4V: Functional Mechanism of Structural Transformation

Nanoengineered Polycrystalline Diamond Composites with Advanced Wear Resistance and Thermal Stability

Electronic insight into ultralow friction in hydrogenated diamond

Proposition of a robot-based free diamond abrasive grinding process and its influence on the characteristics of plasma-sprayed 8YSZ coatings

The friction and wear properties of polytetrafluoroethylene filled with ultrafine diamond