Abstract:The rapid decarbonisation of the power generation and aviation sectors will require a move away from incremental development, exposing designers and researchers to the risk of unexpected results from uncertainty in boundary layer state. This problem already exists for parts developed with fully turbulent assumptions, but in novel design spaces the risk increases for both real components, where previous knowledge of similar designs may be inapplicable, and particularly in experimental testing of scaled models, where reducing Reynolds number can result in a drastic change in flow topology that skews the conclusions of a test. Computational methods struggle to reliably predict boundary layer state so experimental techniques for diagnosing boundary layer state are needed. Infrared thermography (IR) is a non-invasive technique that offers simple, fast visualisation of boundary layer state with no additional instrumentation. IR is relatively uncommon in the literature and there is minimal information available on the best practices for its use. This paper aims to encourage the adoption of IR as a diagnostic tool by demonstrating routes for optimisation and pointing out pitfalls to avoid. A low-order model is developed and used to predict how the signal-to-noise ratio (SNR) of an IR visualisation changes depending on the thermal design of the test piece. It is shown that in low-speed flows with active heating from the surface the SNR is maximised through a suitable choice of surface insulation, while in high-speed flows, where passive temperature differences are used, there is a crossover between heat transfer and recovery temperature effects that results in an SNR of zero, an effect that can arise in both steady-state and transient experiments. Experimental validation of the 1D model in both flow regimes is shown alongside two case studies on the use of IR in sub-scale testing where uncertainty in boundary layer state results in critical differences from the full-scale flow.

Material Evaluation by Infrared Thermography

Characterisation of thermal property of materials by infrared thermography

Evaluation of building materials using infrared thermography

The use of infrared thermography for materials characterization

Building defects diagnosis by infrared thermography

Infrared camera assessment of skin surface temperature--effect of emissivity

Infrared Thermography for Temperature Measurement and Non-Destructive Testing

Active IR-applications in civil engineering

Mid-infrared spectroscopic thermotransmittance measurements in dielectric materials for thermal imaging

Nde of Composites Delamination by Infrared Thermography

Development and Application of Infrared Thermography Non-Destructive Testing Techniques

Infrared Thermography to Measure Heat Transfer of a Heated Curved Thin Sheet

Infrared Thermography of Complex 3D Printed Components

Analysis of data processing methods for pulsed thermal imaging characterisation of delaminations

Infrared thermographic measurement of the surface temperature and emissivity of glossy materials

Innovations in Building Diagnostics and Condition Monitoring: A Comprehensive Review of Infrared Thermography Applications

Infrared thermography techniques for boundary layer state visualisation

Thermal imaging by scanning photothermal radiometry

Infrared thermometry in high temperature materials processing: influence of liquid water and steam

Infrared Thermography in Wound Care, Surgery, and Sports Medicine: A Review