Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Mode-Localized Z-Axis Accelerometer

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Experimental characterization of a mode-localized acceleration sensor integrating electrostatically coupled resonators

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Research On Accelerometer Based On Multi-Mode Interference

Design and modeling of a MEMS accelerometer based on coupled mode-localized nonlinear resonators under electrostatic actuation

Measurement combination of x- and y-axis accelerations and z-axis angular velocity in a slot-structure resonator

Mode-localized accelerometer in the nonlinear Duffing regime with 75 ng bias instability and 95 ng/√Hz noise floor

Circuit Implementation Enabling Full-Scale Linear Sensing in Mode-Localized Sensors

Design and Optimization of the Resonator in a Resonant Accelerometer Based on Mode and Frequency Analysis

Design of a Novel Low Cross-Axis Sensitivity Micro-Gravity Sandwich Capacitance Accelerometer.

A MEMS Resonant Accelerometer with Sensitivity Enhancement and Adjustment Mechanisms

Design and dynamic analysis of a highly sensitive MEMS gyroscope based on mode localization.

Versatile and Effective Design Platform for Surface Acoustic Wave Accelerometers

Micro-machined Resonant Out-of-plane Accelerometer with a Differential Structure Fabricated by Silicon-on-insulator–mems Technology

A Sensitive Micromachined Resonant Accelerometer for Moving-Base Gravimetry

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement