Abstract:The high-Tc superconducting (HTS) dynamo is a promising device that can inject large DC supercurrents into a closed superconducting circuit. This is particularly attractive to energise HTS coils in NMR/MRI magnets and superconducting rotating machines without the need for connection to a power supply via current leads. It is only very recently that quantitatively accurate, predictive models have been developed which are capable of analysing HTS dynamos and explain their underlying physical mechanism. In this work, we propose to use the HTS dynamo as a new benchmark problem for the HTS modelling community. The benchmark geometry consists of a permanent magnet rotating past a stationary HTS coated-conductor wire in the open-circuit configuration, assuming for simplicity the 2D (infinitely long) case. Despite this geometric simplicity the solution is complex, comprising time-varying spatially-inhomogeneous currents and fields throughout the superconducting volume. In this work, this benchmark problem has been implemented using several different methods, including H-formulation-based methods, coupled H-A and T-A formulations, the Minimum Electromagnetic Entropy Production method, and integral equation and volume integral equation-based equivalent circuit methods. Each of these approaches show excellent qualitative and quantitative agreement for the open-circuit equivalent instantaneous voltage and the cumulative time-averaged equivalent voltage, as well as the current density and electric field distributions within the HTS wire at key positions during the magnet transit. A critical analysis and comparison of each of the modelling frameworks is presented, based on the following key metrics: number of mesh elements in the HTS wire, total number of mesh elements in the model, number of degrees of freedom (DOFs), tolerance settings and the approximate time taken per cycle for each model.

Self Consistent Electrical and Thermal-Hydraulic Model of Faults in Superconducting Magnets: EU DEMO TF Short Circuit During a Fast Discharge

Numerical analysis of non-insulated DEMO TF coils

Commissioning, Performance, and Effect of the Quench Current-boosting Device on a Dedicated Superconducting Magnet

Primary Quench Detection Analysis for the EU-DEMO Toroidal Field Coils

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

3D transient CFD simulation of an in-vessel Loss-Of-Coolant Accident in the EU DEMO fusion reactor

Modeling of Quench in the ITER Poloidal Field Coils

The Role of Advanced Modeling in the Assembly and Operation of Tokamak Magnets

Thermal–hydraulic study of the Primary Heat Transport System of the EU-DEMO Divertor Plasma Facing Components

Design and Performance of a Linear Flux Pump for the Frascati Coil Cold Test Facility

Optimized Field/Circuit Coupling for the Simulation of Quenches in Superconducting Magnets

Electrical Loads and Power Systems for the DEMO Nuclear Fusion Project

Conceptual Design of a Modular EC Heating System for EU-DEMO

Modelling and analysis of quench in the 15-kA HTS conductor

Fault Analysis and Simulation of the Short Circuit in High-Power Fusion Magnet Power Supply

Electromagnetic analysis on conceptual design of the EU DEMO EC equatorial laucher

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

Pulsed DEMO design assessment studies

Status and future development of Heating and Current Drive for the EU DEMO f , Contributors from all Laboratories which have contributed to the Work Package HCD during 2014-2020

A new benchmark problem for electromagnetic modelling of superconductors: the high-Tc superconducting dynamo

Numerical Simulation and Analysis of A Saturated-Core-Type Superconducting Fault Current Limiter