Abstract:In this paper, 2 atom % Al-doped ZnO (AZO) was prepared by the co-precipitation method together with sparking plasma sintering (SPS) treatment. The as-synthesized AZO powders show the morphology of hollow hexagonal towers, which result in a high porosity of 50.6% in the bulk sample consolidated by SPS sintering at 400 °C, and the porosity decreases gradually with increasing sintering temperature up to 1000 °C. Positron annihilation measurements reveal that even after sintering at 1000 °C, there are still a considerable number of small pores. A high electrical conductivity of 3 × 105 S m–1 is achieved at room temperature for the AZO sample sintered at 1000 °C, while the absolute values of Seebeck coefficient keep at relatively high values between 59 and 144 μV K–1 in the measurement temperature range of 27–500 °C, leading to a high power factor of 3.4 × 10–3 W m–1 K–2. On the other hand, the pores in AZO act as strong phonon scattering centers, and an extremely low thermal conductivity of 1.5 W m–1 K–1 measured at room temperature is obtained for AZO sintered at 400 °C. Due to the residual pores in the 1000 °C-sintered sample, the thermal conductivity is still relatively low. As a result, a maximum ZT of 0.275 measured at 500 °C is obtained in this sample, which is the highest ZT reported for ZnO around this temperature.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c16506?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c16506</a>.Thermal gravity analysis for the Al-doped ZnO (Figure S1), TEM images of Al-doped ZnO sintered at different temperatures (Figure S2), and structural characterization and thermoelectric properties of undoped ZnO prepared by co-precipitation combined with SPS treatment (Figures S3–S5) (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c16506/suppl_file/am0c16506_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Defects and microstructure of highly conducting Al-doped ZnO ceramics obtained via spark plasma sintering

Microstructure effects on the local order and electronic defects in (Al, Ti, Mg) co-doped ZnO conductive ceramics

Microstructure and thermoelectric properties of Zn1−xAlxO ceramics fabricated by spark plasma sintering

Microstructure and thermoelectric properties of Al-doped ZnO ceramic prepared by spark plasma sintering

Microstructure and Electrical Properties of Al-doped ZnO Thin Films

Influence of electric current on microstructure and electrical property of Al-doped ZnO ceramic consolidated by spark plasma sintering

The influence of ZrO2 doping on microstructure and electrical properties of ZnO-based conductive ceramics

Fabrication of ZnO Ceramics with Defects by Spark Plasma Sintering Method and Investigations of Their Photoelectrochemical Properties

Microstructural evolution of ZnO via hybrid cold sintering/spark plasma sintering

Study of Electrical and Dielectric Behaviors of Copper-Doped Zinc Oxide Ceramic Prepared by Spark Plasma Sintering for Electronic Device Applications

Enhanced Dielectric Strength and Energy Storage Density in BaTi 0.7 Zr 0.3 O 3 Ceramics Via Spark Plasma Sintering

Defect Dipoles Induced High‐energy Storage Density in Mn‐doped BST Ceramics Prepared by Spark Plasma Sintering

Microstructure and Thermal Conductivity of Spark Plasma Sintering AlN Ceramics

Microstructural, electrical, and mechanical properties of conductive SiC ceramics fabricated by spark plasma sintering

Study on the preparation and the film-forming properties of Mo-and Al-doped ZnO ceramic targets

Defect-driven conductivity behavior in lead-free KNN-based ceramics

Significant Enhancement in the Thermoelectric Performance of Aluminum-Doped ZnO Tuned by Pore Structure

Effect of Sr-doping on sinterability, morphology, structure, photocatalytic activity and AC conductivity of ZnO ceramics

Electric conductivity in Zn2+-substituted lithium sulfate–alumina ceramics

Structure-dependent optical and electrical transport properties of nanostructured Al-doped ZnO

Study on Thermal Conductivity of Spark-Plasma-Sintered Silicon Nitride Ceramics