Abstract:For about 100 years, potentiometry with ion-selective electrodes has been one of the dominating electroanalytical techniques. While great advances in terms of selective chemistries and materials have been achieved in recent years, the basic manner in which ion-selective membranes are used has not fundamentally changed. The potential readings are directly co-dependent on the potential at the reference electrode, which requires maintenance and for which very few accepted alternatives have been proposed. Fouling or clogging of the exposed electrode surfaces will lead to changes in the observed potential. At the same time, the Nernst equation predicts quite small potential changes, on the order of millivolts for concentration changes on the order of a factor two, making frequent recalibration, accurate temperature control and electrode maintenance key requirements of routine analytical measurements. While the relatively advanced selective materials developed for ion-selective sensors would be highly attractive for low power remote sensing application, one should consider solutions beyond classical potentiometry to make this technology practically feasible. This paper evaluates some recent examples that may be attractive solutions to the stated problems that face potentiometric measurements. These include high-amplitude sensing approaches, with sensitivities that are an order of magnitude larger than predicted by the Nernst equation; backside calibration potentiometry, where knowledge of the magnitude of the potential is irrelevant and the system is evaluated from the backside of the membrane; controlled current coulometry with ion-selective membranes, an attractive technique for calibration-free reagent delivery without the need for standards or volumetry; localized electrochemical titrations at ion-selective membranes, making it possible to design sensors that directly monitor parameters such as total acidity for which volumetric techniques were traditionally used; and controlled potential coulometry, where all ions of interest are selectively transferred into the ion-selective organic phase, forming a calibration-free technique that would be exquisitely suitable for remote sensing applications.

Increasing the Sensitivity of pH Glass Electrodes with Constant Potential Coulometry at Zero Current

Perspective on the coulometric transduction principle for ion-selective electrodes

Improvement of the Upper Detection Limit of Ionophore-Based H + -Selective Electrodes: Explanation and Elimination of Apparently Super-Nernstian Responses

Beyond potentiometry: robust electrochemical ion sensor concepts in view of remote chemical sensing

All-solid-state Potentiometric Sensor Using Single-Walled Carbon Nanohorns As Transducer

Polymeric membrane ion-selective electrode based on potential-modulated ion transfer: Ultrasensitive measurement of oceanic pH

Nonequilibrium Anion Detection in Solid-Contact Ion-Selective Electrodes

Photoelectrochemical conversion for ion-selective electrodes based on CdS semiconductor film

Chemically Induced pH Perturbations for Analyzing Biological Barriers Using Ion-Sensitive Field-Effect Transistors

New Signal Readout Principle for Solid-Contact Ion-Selective Electrodes

Beyond the Nernst-limit with dual-gate ZnO ion-sensitive field-effect transistors

Effect of Ion Identity on Capacitance and Ion-to-Electron Transduction in Ion-Selective Electrodes with Nanographite and Carbon Nanotube Solid Contacts

Exploiting the pH-Cross Sensitivity of Ion-Selective Optodes to Broaden Their Response Range

Amperometric Response of Solid-Contact Ion-Selective Electrodes Utilizing a Two-Compartment Cell and a Redox Couple in Solution

Covalently Attached Ionophores to Extend the Working Range of Potentiometric pH Sensors with Poly(decyl methacrylate) Sensing Membranes

Micro- and Nanofluidic pH Sensors Based on Electrodiffusioosmosis

Mesoporous Carbon Structure-Based Glass Nanopipettes as Micro pH Probes

Optimization of an electrolyte conductivity detector for measuring low ion concentrations

Smart pH Sensing: A Self-Sensitivity Programmable Platform with Multi-Functional Charge-Trap-Flash ISFET Technology

Potential of Zero Charge Measurement By Second Harmonic Generation

Pressure-Controlled Nanopipette Sensing in the Asymmetric-Conductivity Configuration