Low energy-consuming CO2 capture by phase change absorbents of amine/alcohol/H2O

Xiaoshan Li,Ji Liu,Wufeng Jiang,Ge Gao,Fan Wu,Cong Luo,Liqi Zhang
DOI: https://doi.org/10.1016/j.seppur.2021.119181
IF: 8.6
2021-11-01
Separation and Purification Technology
Abstract:Phase change absorbents have recently drawn increasing attention due to the potential of for low energy-consuming CO2 capture. When forming two phases after CO2 absorption, only the CO2-rich phase is heated in the desorption process thus reducing the sensible heat. In this work, five amine and three alcohol blends were used to investigate their phase change behavior after reacting with CO2. Phase separation could easily occur for DETA/alcohol/water combinations after CO2 absorption, which was confirmed by the large difference of the solvation free energy in alcohol and in water (i.e. DETA-CO2 has 12.5 kcal/mol ΔGsol in 1-propanol less than that in water). The optimization of the DETA/1-propanol/H2O solution was confirmed to be 30% DETA + 30% 1-propanol + 40% H2O (D30P30H40). It was found that above 90% of CO2 loading was enriched in lower phase. 13C NMR spectrum indicated that carbamate and bicarbonate was formed in lower phase and 1-propanol acted as a good physical solvent to trigger phase separation and facilitate the reaction between amine and CO2.
engineering, chemical
What problem does this paper attempt to address?
The paper aims to address the issue of high energy consumption during the carbon dioxide (CO2) capture process. Although traditional chemical absorption methods can effectively capture CO2, the regeneration process requires a large amount of energy, especially for heating a significant amount of water, leading to increased industrial operating costs. Therefore, researchers are dedicated to developing low-energy CO2 capture technologies. To achieve this goal, the paper explores the application of phase change absorbents in CO2 capture. Phase change absorbents form two phases after absorbing CO2, where the CO2-rich phase is regenerated by heating, while the CO2-lean phase does not require treatment, thereby significantly reducing energy consumption during the regeneration process. Specifically, the researchers screened combinations of five amines and three alcohols, and through experiments and quantum chemical calculations, optimized the ratio of DETA/1-propanol/H2O solution, ultimately determining the optimal ratio of 30% DETA + 30% 1-propanol + 40% H2O (D30P30H40). The study shows that this phase change absorbent exhibits good performance in capturing CO2 and can significantly reduce energy consumption during the regeneration process, demonstrating potential for application in CO2 capture in coal-fired power plants.