Abstract:The study systematically investigates the ductile-brittle transition behavior, material removal mechanism, and end-face turning performance of binderless tungsten carbide using in-process-heat laser-assisted diamond machining. Both numerical simulation analysis and experimental cutting experiments were conducted. To ensure that the laser loading condition and energy distribution were consistent with the ray-tracing simulation and spatial power density distribution measurement, a practical thermal simulation model was created with a semicircular Gaussian distribution. This model was then used to study the temperature distribution, and the material's thermal transient response to laser radiation was also analyzed in detail. The high-temperature nanoindentation revealed increased ductile machinability due to plastic deformation, microhardness reduction, and Young's modulus decrease at elevated temperatures, providing fundamental support for the ductile-brittle transition behavior. The ductile-brittle transition depth increased by 247.20% compared to conventional groove cutting without laser assistance. The cutting forces during groove cutting decreased gradually with increasing laser power, but excess laser power may cause fluctuations in cutting forces due to surface high-temperature oxidation and potential thermal expansion. The ductile-brittle transition dynamic behavior analysis, based on the discrete wavelet transform algorithm, showed good consistency with the conventional groove profile analysis. The friction coefficient between the tool rake face and chip decreased with increasing laser power, which facilitated improving the tool life. The statistical analysis of end-face turning experiments based on the Taguchi method indicated that laser power was the most significant factor affecting surface quality. The verification turning experiments validated the determined optimal parametric combination. Ultra-high-quality spherical lenses were obtained in ductile cutting mode with slightly less tool wear, a more homogeneous finish (less than 3 nm in Sa), and more outstanding form accuracy (133 nm in PV) compared to conventional turning without laser assistance.

A study on the cutting efficiency of gas-laser hybrid cutting according to the optimal cutting speed when cutting 100 mm ultra-thick plates

Cutting Temperature and Force Data Acquisition and Measuring System Design in High Speed Machining

Feasibility analysis and cutting process research on laser cutting medium-thick 20CrNiMo steel plates using a high-power fiber laser without assisted blowing

Research on Influence Mechanism of Nozzle Structure on Properties of Thick Carbon Steel Plate by Laser Cutting

Laser and oxygen hybrid coaxial cutting method for thick clad plates made of heterogeneous metals

Hybrid modeling and optimization of fiber laser hole cutting of austenitic stainless-steel sheets using response surface

Response surface methodology-based optimization of parameters and cutting quality of 22MnB5 plates by UV picosecond laser layered cutting

Comparative study of the influence of the gas injection system on the Nd:yttrium-aluminum-garnet laser cutting of advanced oxide ceramics

A comprehensive review of studying the influence of laser cutting parameters on surface and kerf quality of metals

Development of Equipment and Technology for Precision Air-Plasma Cutting of Plate Steel

Experimental Investigation of Industrial Laser Cutting: The Effect of the Material Selection and the Process Parameters on the Kerf Quality

Effect of Fiber-Laser Parameters on Cutting Accuracy of Thin and Thick S355JR Structural Steel Plates

An Efficient High-Quality Cutting Method for Thick SiC f /SiC Ceramic Matrix Composites Using UV Laser Multiline Layered Scanning with Focus Increment Optimization

Experimental study on laser cutting process of simulated fast Reactor fuel rods

Use of a diffractive optic for high power laser cutting

Ultra-precision cutting characteristics of binderless tungsten carbide by in-heat-process laser-assisted diamond machining

Evaluation and Optimal Design of Supersonic Nozzle for Laser-Assisted Oxygen Cutting of Thick Steel Sections

Optimizing laser-based micro-cutting for PMMA microfluidic device fabrication: thermal analysis and parameter optimization

Effects of heat source configuration on the welding process and joint formation in ultra-high power laser-MAG hybrid welding

Thermal analysis of in-situ laser assisted diamond cutting of fused silica and process optimization

Thick Glass High-Quality Cutting by Ultrafast Laser Bessel Beam Perforation-Assisted Separation