Abstract:The lithium silicates have attracted scientific interest due to their potential use as high-temperature sorbents for CO2 capture. The electronic properties and thermodynamic stabilities of lithium silicates with different Li2O/SiO2 ratios (Li2O, Li8SiO6, Li4SiO4, Li6Si2O7, Li2SiO3, Li2Si2O5, Li2Si3O7, and α-SiO2) have been investigated by combining first-principles density functional theory with lattice phonon dynamics. All these lithium silicates examined are insulators with band-gaps larger than 4.5 eV. By decreasing the Li2O/SiO2 ratio, the first valence bandwidth of the corresponding lithium silicate increases. Additionally, by decreasing the Li2O/SiO2 ratio, the vibrational frequencies of the corresponding lithium silicates shift to higher frequencies. Based on the calculated energetic information, their CO2 absorption capabilities were extensively analyzed through thermodynamic investigations on these absorption reactions. We found that by increasing the Li2O/SiO2 ratio when going from Li2Si3O7 to Li8SiO6, the corresponding lithium silicates have higher CO2 capture capacity, higher turnover temperatures and heats of reaction, and require higher energy inputs for regeneration. Based on our experimentally measured isotherms of the CO2 chemisorption by lithium silicates, we found that the CO2 capture reactions are two-stage processes: (1) a superficial reaction to form the external shell composed of Li2CO3 and a metal oxide or lithium silicate secondary phase and (2) lithium diffusion from bulk to the surface with a simultaneous diffusion of CO2 into the shell to continue the CO2 chemisorption process. The second stage is the rate determining step for the capture process. By changing the mixing ratio of Li2O and SiO2, we can obtain different lithium silicate solids which exhibit different thermodynamic behaviors. Based on our results, three mixing scenarios are discussed to provide general guidelines for designing new CO2 sorbents to fit practical needs.

Thermodynamic Investigations for Combustion-Assisted Synthesis of Lithium Orthosilicate Powders

Optimization of Li4SiO4 synthesis conditions by a solid state method for maximum CO2 capture at high temperature

CO2 capture properties of lithium silicates with different ratios of Li2O/SiO2: an ab initio thermodynamic and experimental approach

Solution combustion synthesis derived Li4SiO4 for post-combustion carbon capture

Molten shell-activated, high-performance, un-doped Li4SiO4 for high-temperature CO2 capture at low CO2 concentrations

Evaluation of the formation and carbon dioxide capture by Li4SiO4 using in situ synchrotron powder X-ray diffraction studies

Synthesis and Adsorption Process of Lithium Taking Used as High-Temperature CO2 Sorbents

Promotion of MgO Sorbents with Eutectic Carbonate Doping for High-Temperature and Pressure CO2 Capture

Time-Resolved Synchrotron Powder X-ray Diffraction Studies on the Synthesis of Li8SiO6 and Its Reaction with CO2

Carbon dioxide absorption in packed bed of lithium orthosilicate pebbles

CO2 high-temperature sorbent (Al, Fe, Ti) CO-doped Li4SiO4 from fly ash-derived SiO2 aerogel: In-situ synthesis, enhanced capture ability and long cycle stability

Preparation and Kinetic Analysis of Li 4 SiO 4 Sorbents with Different Silicon Sources for High Temperature CO 2 Capture

Study on factors in synthesis of lithium orthosilicates powder by solid state reaction method

Kinetic analysis for cyclic CO 2 capture using lithium orthosilicate sorbents derived from different silicon precursors.

High-temperature CO2 sorption over Li4SiO4 synthesized from diatomite: study of sorption heat and isotherm modeling

Kinetics of novel Li_4SiO_4 absorbing CO_2 at high temperature

Influence of the concentration of CO2 and SO2 on the absorption of CO2 by a lithium orthosilicate-based absorbent

Dilithium Dialuminium Trisilicate Crystalline Phase Prepared from Coal Fly Ash

Enhanced high temperature cyclic CO2 capture on Li4SiO4 sorbent from two-dimensional SiO2 nanomeshes

Structurally improved Li4SiO4 sorbents derived from lithium salicylate precursor for enhanced CO2 capture

Novel Li4SiO4-based Sorbents from Diatomite for High Temperature CO2 Capture