Abstract:The fiber distribution is a crucial factor governing the superb strain-hardening and multiple cracking behavior of engineered cementitious composites (ECC). However, the desired uniform distribution of fibers is challenging in ECC with large amounts of binders and fibers, especially for hybrid fiber system. In the present study, we employed image analysis to investigate the fiber distribution characteristics in hybrid steel-polyvinyl alcohol (PVA) fiber ECC and its influence on the mechanical performance. Special attention was paid to the impact of additional steel fiber content and its size. The results show that the dispersion coefficient of PVA fibers in hybrid fiber system was at most 50% higher than that of mono fiber system. Fiber hybridization rendered more fibers distributed in smaller angles of 0 degrees -40 degrees, which helped to enhance the fiber bridging capacity. The addition of steel fibers significantly improved the flexural properties of ECC, with maximized strength at steel fiber content of 1.0% and maximized deformability at 0.6% dosage. The incorporation of steel fibers greatly enhanced the crack control ability of hybrid fiber ECC. The average crack width was reduced to 36.1 mu m when the volume fraction of steel fiber gone to 1.0%. Furthermore, larger sized steel fibers played a more pronounced role in improving the fiber dispersion, fiber orientation and mechanical properties than that with smaller size. Synergy effect of hybrid steel-PVA fiber on fiber distribution and mechanical properties was revealed. The findings are expected to contribute to the blending ratio design of hybrid fibers and the selection of fiber size in preparing ECC. And the obtained robust ECC can provide strong support for performance enhancement and maintenance of building engineering.

Experimental and theoretical investigations on flexural performance of hybrid fiber reinforced ECC-NC composite beams

Flexural behaviour of high strength engineered cementitious composites (ECC)-reinforced concrete composite beams

Investigation of the flexural behavior of reinforced concrete beams strengthened with a composite reinforcement layer: Polyvinyl alcohol fiber‐reinforced ferrocement cementitious composite and steel wire mesh

Experimental investigation on flexural performance of concrete beams strengthened with SMA-GFRP-ECC smart composite materials

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

XFEM Investigation of Engineered Cementitious Composite in Reinforced and Plain Beam Based on Experimental Results

Experimental investigation on seismic performance of plain engineered cementitious composite beams

Flexural Performance of Layered ECC-concrete Composite Beam

Numerical Simulation of Engineering Cementitious Composite Beams Strengthened with Fiber-Reinforced Polymer and Steel Bars

Flexural Behaviors of Rc Beams Strengthened with Post-Poured Uhtcc Layer

Flexural performance of 3D-printed composite beams with ECC and recycled fine aggregate concrete: Experimental and numerical analysis

Simulation and test of flexural performance of polyvinyl alcohol-steel hybrid fiber reinforced cementitious composite

Flexural and bond-slip behaviours of engineered cementitious composites encased steel composite beams

Flexural performance of FRP-SWSSC-steel composite beams: Experimental and analytical investigation

Flexural Properties of ECC-Concrete Composite Beam

Development of theoretical model for predicting flexural behavior of GFRP reinforced concrete beams with CFRP grid‐reinforced ECC

Synergy Effect of Hybrid Steel-Polyvinyl Alcohol Fibers in Engineered Cementitious Composites: Fiber Distribution and Mechanical Performance

Experimental Study on the Flexural Performance of Steel–Polyvinyl Alcohol Hybrid Fiber-Reinforced Concrete

Experimental and theoretical study on flexural behavior of steel-concrete composite beams strengthened by CFRP plates with unbonded retrofit systems

Flexural Behavior of Steel-Mpc Based High Performance Concrete Composite Beams Subjected to Hogging Moments

Experimental and Numerical Study on Steel-Concrete Composite Frames with Engineered Cementitious Composites