Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

Effects of Fluorination and Molybdenum Codoping on Monoclinic BiVO Photocatalyst by HSE Calculations.

Photocatalytic and photoelectrochemical water oxidation over metal-doped monoclinic BiVO(4) photoanodes

Enhanced Photocatalytic Performance of Visible-Light-Driven BiVO4 Nanoparticles through W and Mo Substituting

Effects of Mo Replacement on the Structure and Visible-Light-Induced Photocatalytic Performances of Bi2wo6 Photocatalyst

Electron polarons in the subsurface layer of Mo/W-doped BiVO4 surfaces

The hydrophilic treatment of a novel co-catalyst for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

Characterization of the electronic structure of sputter-deposited Mo-doped BiVO4 thin-film photoanodes

Formation Energy and Photoelectrochemical Properties of Bivo4 after Doping at Bi3+ or V5+ Sites with Higher Valence Metal Ions

A novel co-catalyst of CoFeOOH for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

Improved Surface Charge Transfer in MoO3/BiVO4 Heterojunction Film for Photoelectrochemical Water Oxidation

Enhanced Photoelectrochemical Water Oxidation Performance on BiVO4 by Coupling of CoMoO4 As a Hole-Transfer and Conversion Cocatalyst.

Correlation between Dynamics of Polaronic Photocarriers and Photoelectrochemical Performance in Mo-Doped Bismuth Vanadate

The aerosol-assisted chemical vapour deposition of Mo-doped BiVO 4 photoanodes for solar water splitting: an experimental and computational study

Enhancing the photoelectrochemical activity of monoclinic BiVO4 by discretizing oxygen vacancies: insights from DFT calculations

Mo or W Doping into the Surface of BiVO4 Film Photoanodes Through a Photoelectrochemical Treating Approach for Efficient Solar Water Oxidation

Enhanced bulk and interfacial charge transfer in Fe:VOPO4 modified Mo:BiVO4 photoanodes for photoelectrochemical water splitting

Structure, morphology and photocatalytic performance of europium and flourine co-doped bismuth vanadate

Improved Performance of BiVO4 via a Surface Deposited Magnetic CuFe2O4 for Phenol Oxidation, O2 Reduction and Evolution under Visible Light.

Oxygen vacancy and Van der Waals heterojunction modulated interfacial chemical bond over Mo2C/Bi4O5Br2 for boosting photocatalytic CO2 reduction

Polyhedron BiVO4 co-doped by Mo and Y for visible light-driven photocatalytic overall water splitting