Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

Characterization of the electronic structure of sputter-deposited Mo-doped BiVO4 thin-film photoanodes

Enhancing Mo:BiVO4 Solar Water Splitting with Patterned Au Nanospheres by Plasmon‐Induced Energy Transfer

Mo-doped BiVO4 photoanodes synthesized by reactive sputtering

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

BiVO4 Ceramic Photoanode with Enhanced Photoelectrochemical Stability

Doping Strategy to Promote the Charge Separation in Bivo4 Photoanodes

Photocatalytic and photoelectrochemical water oxidation over metal-doped monoclinic BiVO(4) photoanodes

Mo or W Doping into the Surface of BiVO4 Film Photoanodes Through a Photoelectrochemical Treating Approach for Efficient Solar Water Oxidation

Direct Liquid Injection Chemical Vapor Deposition of Molybdenum-Doped Bismuth Vanadate Photoelectrodes for Efficient Solar Water Splitting

Correlation between Dynamics of Polaronic Photocarriers and Photoelectrochemical Performance in Mo-Doped Bismuth Vanadate

Effects of Fluorination and Molybdenum Codoping on Monoclinic BiVO Photocatalyst by HSE Calculations.

Enhanced bulk and interfacial charge transfer in Fe:VOPO4 modified Mo:BiVO4 photoanodes for photoelectrochemical water splitting

MoO3 with the Synergistic Effect of Sulfur Doping and Oxygen Vacancies: The Influence of S Doping on the Structure, Morphology, and Optoelectronic Properties

Unconventional Relation between Charge Transport and Photocurrent via Boosting Small Polaron Hopping for Photoelectrochemical Water Splitting

Formation Energy and Photoelectrochemical Properties of Bivo4 after Doping at Bi3+ or V5+ Sites with Higher Valence Metal Ions

Unveiling the Influence of Sulfur Doping on Photoelectrochemical Performance in BiVO 4 /FeOOH Heterostructures

The aerosol-assisted chemical vapour deposition of Mo-doped BiVO 4 photoanodes for solar water splitting: an experimental and computational study

Metal Doping of BiVO 4 by Composite Electrodeposition with Improved Photoelectrochemical Water Oxidation

Boosting charge transfer via molybdenum doping and electric-field effect in bismuth tungstate: Density function theory calculation and potential applications

Enhanced Photocatalytic Performance of Visible-Light-Driven BiVO4 Nanoparticles through W and Mo Substituting

Enhanced Photoelectrochemical Water Oxidation Performance on BiVO4 by Coupling of CoMoO4 As a Hole-Transfer and Conversion Cocatalyst.