Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

Mo-doped BiVO4 photoanodes synthesized by reactive sputtering

Dual Modification of BiVO4 Photoanode by Enriching Bulk and Surface Oxygen Vacancies for Enhanced Photoelectrochemical Performance.

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

Mo or W Doping into the Surface of BiVO4 Film Photoanodes Through a Photoelectrochemical Treating Approach for Efficient Solar Water Oxidation

Enhancing Mo:BiVO4 Solar Water Splitting with Patterned Au Nanospheres by Plasmon‐Induced Energy Transfer

Synergy Effect of the Enhanced Local Electric Field and Built-In Electric Field of CoS/Mo-Doped BiVO4 for Photoelectrochemical Water Oxidation.

Characterization of the electronic structure of sputter-deposited Mo-doped BiVO4 thin-film photoanodes

Fabrication of electrochemically-modified BiVO

The aerosol-assisted chemical vapour deposition of Mo-doped BiVO 4 photoanodes for solar water splitting: an experimental and computational study

Photocatalytic and photoelectrochemical water oxidation over metal-doped monoclinic BiVO(4) photoanodes

Enhanced bulk and interfacial charge transfer in Fe:VOPO4 modified Mo:BiVO4 photoanodes for photoelectrochemical water splitting

In situ preparation of Mo: BiVO4 photoanodes coupled with BiOBr cathode for efficient photoelectrocatalytic CO2 reduction performance

A novel co-catalyst of CoFeOOH for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

High-performance bismuth vanadate photoanodes cocatalyzed with nitrogen, sulphur co-doped ferrocobalt-metal organic frameworks thin layer for photoelectrochemical water splitting

Interface Modulation of BiVO4 Based Photoanode with Bi(III)Bi(V)O4 for Enhanced Solar Water Splitting

The hydrophilic treatment of a novel co-catalyst for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

Photoelectrodes Based Upon Mo:BiVO4 Inverse Opals for Photoelectrochemical Water Splitting.

Direct Liquid Injection Chemical Vapor Deposition of Molybdenum-Doped Bismuth Vanadate Photoelectrodes for Efficient Solar Water Splitting

BiVO4 Ceramic Photoanode with Enhanced Photoelectrochemical Stability

MoO3/BiVO4 Heterojunction Film with Oxygen Vacancies for Efficient and Stable Photoelectrochemical Water Oxidation

Cobalt-Modified Amorphous Nickel–Iron–Molybdate Cocatalysts to Enhance the Photoelectrochemical Water Splitting Performance of BiVO 4 Photoanodes