Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

Cobalt-Modified Amorphous Nickel–Iron–Molybdate Cocatalysts to Enhance the Photoelectrochemical Water Splitting Performance of BiVO 4 Photoanodes

In Situ Activation of Amorphous NiFeMo Oxide Cocatalyst To Improve the Photoelectrochemical Water Splitting Performance of BiVO 4

A novel co-catalyst of CoFeOOH for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

High-performance bismuth vanadate photoanodes cocatalyzed with nitrogen, sulphur co-doped ferrocobalt-metal organic frameworks thin layer for photoelectrochemical water splitting

The hydrophilic treatment of a novel co-catalyst for greatly improving the solar water splitting performance over Mo-doped bismuth vanadate

Boosting Photoelectrochemical Water Oxidation Performance of Nanoporous BiVO4 Via Dual Cocatalysts Cobaloxime and Ni-OEC Modification

Boosting Solar Water Oxidation Activity and Stability of BiVO4 Photoanode Through the Co-catalytic Effect of CuCoO2

Doping with Rare Earth Elements and Loading Cocatalysts to Improve the Solar Water Splitting Performance of BiVO4

Efficient Suppression of Surface Charge Recombination by CoP-Modified Nanoporous BiVO4 for Photoelectrochemical Water Splitting

Enhanced Photoelectrochemical Water Oxidation Performance on BiVO4 by Coupling of CoMoO4 As a Hole-Transfer and Conversion Cocatalyst.

Green light all the way: Triple modification synergistic modification effect to enhance the photoelectrochemical water oxidation performance of BiVO4 photoanode

Boosting the Photoactivity of BiVO4 Photoanodes by a ZnCoFe-LDH Thin Layer for Water Oxidation

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

A Molecular Cobaloxime Cocatalyst and Ultrathin FeOOH Nanolayers Co-Modified BiVO 4 Photoanode for Efficient Photoelectrochemical Water Oxidation

Synergistic Effect of Co3(HPO4)2(OH)2 Cocatalyst and Al2O3 Passivation Layer on BiVO4 Photoanode for Enhanced Photoelectrochemical Water Oxidation

High-performance BiVO4 photoanodes cocatalyzed with bilayer metal–organic frameworks for photoelectrochemical application

Coupling surface modification with cocatalyst deposition on BiVO4 photoanode to enhance charge transfer for efficient solar-driven water splitting

Anchored Ni nanocrystals boosting BiVO<sub>4</sub> photoanode for highly efficient water oxidation via in-situ generation of Ni@NiOOH co-catalyst

Anchored Ni nanocrystals boosting BiVO4 photoanode for highly efficient water oxidation via in-situ generation of Ni@NiOOH co-catalyst

Unveiling the effect of the structural transformation of CoZn-MOF on BiVO4 photoanode for efficient photoelectrochemical water oxidation

NdCo3 Molecular Catalyst Coupled with a BiVO4 Photoanode for Photoelectrochemical Water Splitting