Abstract:Die filling from a stationary shoe in a vacuum and in the presence of air was numerically, analyzed using an Eulerian-Lagrangian model, which employs a discrete element method (DEM) for the particles and computational fluid dynamics (CFD) for the air with a two-way air-particle interaction coupling term. Monodisperse and polydisperse powder systems have been simulated to explore the effect of the presence of air on the die filling process. For die filling with monodisperse powders, the influences of particle size and density on the flow behavior were explored. The numerical simulations revealed that the presence of air has a significant impact on the powder flow behavior, especially for systems with smaller and/or lighter particles. Flow has been characterized in terms of a dimensionless mass flow rate, and it has been shown that for die filling in a vacuum this is constant. The flow characteristics for die filling in air can be classified into two regimes. There is an air-inert regime in which the particle size and density are sufficiently large that the effect of air flow becomes negligible, and the dimensionless mass flow rate is essentially identical to that obtained for die filling in a vacuum. There is also an air-sensitive regime, for smaller particle sizes and lower particle densities, in which the dimensionless mass flow rate increases as the particle size and density increase. The effects of particle-size distribution and adhesion on the flow behavior have also been investigated. It was found that, in a vacuum, the dimensionless mass flow, rate for polydisperse systems is nearly identical to that for monodisperse systems. In the presence of air, a lower dimensionless mass flow rate is obtained for polydisperse systems compared to monodisperse systems, demonstrating that air effects become more significant. Furthermore, it has been shown that, as expected, the dimensionless mass flow rate decreases as the surface energy increases (i.e., for more cohesive powders). (C) 2008 American Institute of Chemical Engineers AIChE J, 55: 49-62, 2009

Influence of the "Left Span" on flow and fluidization characteristics of cohesive powders

The Influence of Particle-Size Distribution on Critical State Behavior of Spherical and Non-Spherical Particle Assemblies

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Validation of Surface Coating with Nanoparticles to Improve the Flowability of Fine Cohesive Powders

Gas and Powder Flow Characteristics of Packed Bed: A Two-way Coupled CFD-DEM Study

The Effect of Process Conditions on Powder Flow Properties for Slow Flow Regimes

A mechanistic framework for the characterisation of cohesive, frictional and interlocking effects on powder flow behaviour

Effect of Cohesive Particle Addition on Bubbling Characteristics of Gas-Solid Fluidized Bed: Meso-scale Mechanism

A Coupled Dem/Cfd Analysis of the Effect of Air on Powder Flow During Die Filling

Effect of Cohesion on Granular-Fluid Flows in Spouted Beds: PIV Measurement and DEM Simulations

A Numerical Investigation on Segregation in Gas-Fluidized Beds of Short, Flexible Fibers

A Coupled DEM/CFD Analysis of Die Filling Process

Bubble Dynamics and Particle Orientation in a Binary Fluidized Bed Containing Spherocylinders and Spheres

Multi-Scale Study of Particle Flow in Silos

Controlling factors determining flowability of powders for additive manufacturing: A combined experimental and simulation study

Cohesive Powder Flow: Trends and Challenges in Characterisation and Analysis

Effect of powder morphology on flowability and spreading behavior in powder bed fusion additive manufacturing process: a particle-scale modeling study

Decoding powder flowability: Machine learning pioneers the analysis of particle-size distribution effects

Effects of Cohesion on the Flow Patterns of Granular Materials in Spouted Beds.

Influence of powder size on defect generation in laser powder bed fusion of AlSi10Mg alloy

Comprehensive evaluation of powder flowability for additive manufacturing using principal component analysis