Abstract:Scan-free grazing-emission X-ray fluorescence spectroscopy (GEXRF) is an established technique for the investigation of the elemental depth-profiles of various samples. Recently it has been applied to investigating structured nanosamples in the tender X-ray range. However, lighter elements such as oxygen, nitrogen or carbon cannot be efficiently investigated in this energy range, because of the ineffective excitation. Moreover, common CCD detectors are not able to discriminate between fluorescence lines below 1 keV. Oxygen and nitrogen are important components of insulation and passivation layers, for example, in silicon oxide or silicon nitride. In this work, scan-free GEXRF is applied in proof-of-concept measurements for the investigation of lateral ordered 2D nanostructures in the soft X-ray range. The sample investigated is a Si3N4 lamellar grating, which represents 2D periodic nanostructures as used in the semiconductor industry. The emerging two-dimensional fluorescence patterns are recorded with a CMOS detector. To this end, energy-dispersive spectra are obtained via single-photon event evaluation. In this way, spatial and therefore angular information is obtained, while discrimination between different photon energies is enabled. The results are compared to calculations of the sample model performed by a Maxwell solver based on the finite-elements method. A first measurement is carried out at the UE56-2 PGM-2 beamline at the BESSY II synchrotron radiation facility to demonstrate the feasibility of the method in the soft X-ray range. Furthermore, a laser-produced plasma source (LPP) is utilized to investigate the feasibility of this technique in the laboratory. The results from the BESSY II measurements are in good agreement with the simulations and prove the applicability of scan-free GEXRF in the soft X-ray range for quality control and process engineering of 2D nanostructures. The LPP results illustrate the chances and challenges concerning a transfer of the methodology to the laboratory.

Laboratory‐based 3D X‐ray standing‐wave analysis of nanometre‐scale gratings

Grazing-incidence Small Angle X-Ray Scattering Studies of Nanoscale Polymer Gratings

Small angle x-ray scattering metrology for sidewall angle and cross section of nanometer scale line gratings

Grazing incidence-X-ray fluorescence for a dimensional and elemental characterization of well-ordered nanostructures

Three-dimensional X-ray structural microscopy with submicrometre resolution

High-Resolution Scanning X-ray Diffraction Microscopy

Scan-Free GEXRF in the Soft X-ray Range for the Investigation of Structured Nanosamples

Advanced experimental applications for x-ray transmission gratings spectroscopy using a novel grating fabrication method

Application of laboratory micro X-ray fluorescence devices for X-ray topography

Applied Nanofabrication for X-ray Grating Spectroscopy

Critical-dimension scanning electron microscope characterization of smoothly varying wave structures with a Monte Carlo simulation

Towards scanning nanostructure X‐ray microscopy

X-ray wavefront sensing and optics metrology using a microfocus x-ray grating interferometer with electromagnetic phase stepping

Diffractive small angle X-ray scattering imaging for anisotropic structures

Approaches for the RCWA-based non-destructive characterization of subwavelength-structured gratings

Fabrication of High-Aspect Ratio Nanogratings for Phase-based X-ray Imaging

X-ray Linear Dichroic Tomography of Crystallographic and Topological Defects

Towards Sub-micrometer High Aspect Ratio X-ray Gratings by Atomic Layer Deposition of Iridium

High-resolution 3D X-ray diffraction microscopy: 3D mapping of deformed metal microstructures

First X‐ray spectral ptychography and resonant ptychographic computed tomography experiments at the SWING beamline from Synchrotron SOLEIL

X‐Ray Multibeam Ptychography at up to 20 keV: Nano‐Lithography Enhances X‐Ray Nano‐Imaging