Abstract:Multi-way principal component analysis（MPCA）has received considerable attention and been widely used in process monitoring.A traditional MPCA algorithm unfolds multiple batches of historical data into a two-dimensional matrix and cut the matrix along the time axis to form subspaces.However,low efficiency of subspaces and difficult fault isolation are the common disadvantages for the principal component model.This paper presents a new subspace construction method based on kernel density estimation function that can effectively reduce the storage amount of the subspace information.The MPCA model and the knowledge base are built based on the new subspace.Then,fault detection and isolation with the squared prediction error（SPE）statistic and the Hotelling（T2）statistic are also realized in process monitoring.When a fault occurs,fault isolation based on the SPE statistic is achieved by residual contribution analysis of different variables.For fault isolation of subspace based on the T2 statistic,the relationship between the statistic indicator and state variables is constructed,and the constraint conditions are presented to check the validity of fault isolation.Then,to improve the robustness of fault isolation to unexpected disturbances,the statistic method is adopted to set the relation between single subspace and multiple subspaces to increase the corrective rate of fault isolation.Finally fault detection and isolation based on the improved MPCA is used to monitor the automatic shift control system（ASCS）to prove the correctness and effectiveness of the algorithm.The research proposes a new subspace construction method to reduce the required storage capacity and to prove the robustness of the principal component model,and sets the relationship between the state variables and fault detection indicators for fault isolation.

Process monitoring and fault diagnosis method combining bagging DPCA‐ICA with moving window Kolmogorov–Smirnov test

Process monitoring and fault detection based on multivariate statistical projection analysis

Fault Detection and Isolation of Non-Gaussian and Nonlinear Processes Based on Statistics Pattern Analysis and the K-Nearest Neighbor Method

Fault diagnosis in industrial processes using principal component analysis and hidden Markov model

Research on Process Monitoring Method Based on Independent Component Analysis

Chemical Process Monitoring and Fault Diagnosis Based on Independent Component Analysis

Multi-mode process monitoring method based on PCA mixture model

Dynamic PCA-based Fault Detection and Diagnosis Analysis

A new multivariate statistical process monitoring method using modified fast ICA

Process monitoring based on independent Component Analysis-Principal Component Analysis (ICA-PCA) and similarity factors

Investigation of Dynamic Multivariate Chemical Process Monitoring

ICA AND ITS APPLICATION TO CHEMICAL PROCESS MONITORING AND FAULT DIAGNOSIS

Fault detection method based on kernel principal angle

Fault detection behavior analysis of pca-based process monitoring approach

Fault Detection Behavior And Performance Analysis Of Principal Component Analysis Based Process Monitoring Methods

Fault Diagnosis Method Based on Moving Window PCA

Online fault monitoring for batch processes based on adaptive multi-model ICA-SVDD

Dynamic process fault detection and diagnosis based on dynamic principal component analysis, dynamic independent component analysis and Bayesian inference

Ascs Online Fault Detection and Isolation Based on an Improved Mpca

Process Monitoring and Fault Diagnosis of Condenser Using KPCA and PSVM

A Novel Combination Method for On-line Process Monitoring and Fault Diagnosis