Abstract:The inhomogeneous distributions of basal plane dislocations (BPDs) in PVT-grown 4H-SiC crystal boule due to internal stresses cause lattice plane bending, which strongly affect SiC-based device fabrication. The relationship between BPDs and local basal plane bending in 6-inch 4H-SiC substrates has been investigated. Synchrotron monochromatic beam x-ray topography (SMBXT) imaging shows black and white contrast of BPDs with Burgers vectors of opposite signs based on the principle of ray tracing. We have evaluated the net difference of BPDs with black and white contrast along both [112¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{2}$$\end{document}0] and [11¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{1}$$\end{document}00] radial directions on the Si face across multiple 6-inch diameter 4H-SiC substrates sliced from the same and different boules and predicted the nature (concave/convex) and amount of bending of the basal plane in these wafers. Line scans of 0008 reflection using high resolution x-ray diffractometry (HRXRD) has been carried out along the two directions to verify the nature of bending in these wafers. Results show quite different bending behavior along [112¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{2} $$\end{document}0] and [11¯\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$ \bar{1}$$\end{document}00] directions, indicating that the Si face of 6-inch substrates creates non-isotropic bending on the basal plane. These observations are correlated quite well with net BPD density analysis. The physical shapes of the wafers were also measured to be not flat due to the surface effect. Quantitative analysis of the degree of basal plane bending based on the SMBXT data was carried out and found to be correlating well with the measured tilt angle from HRXRD. Existence of a high stress center was observed in one of the 6-inch wafers resulting in severe bending which is associated with both large bending angles and abrupt changes in lattice constants a and c.

Basal Plane Bending of Homoepitaxial MPCVD Single-Crystal Diamond

Homoepitaxy Growth of Single Crystal Diamond under 300 torr Pressure in the MPCVD System

Homoepitaxial lateral growth of single-crystal diamond with eliminating PCD rim and enlarging surface area

Basal Plane Bending of 4H-Sic Single Crystals Grown by Sublimation Method with Different Seed Attachment Methods

Surface Morphology and Spectroscopic Features of Homoepitaxial Diamond Films Prepared by MWPACVD at High CH4 Concentrations

Effect of basal plane bending on the atomic step morphology of the 4H–SiC substrate surface

Multiple Enlarged Growth of Single Crystal Diamond by MPCVD with PCD-rimless Top Surface

Evolution of surface morphology and optical transmittance of single crystal diamond film by epitaxial growth

Recent progress in homoepitaxial single-crystal diamond growth via MPCVD

Basal Plane Bending of 6H-Sic Single Crystals Observed by Synchrotron Radiation X-Ray Topography

Spatial variation of lattice plane bending of 4H-SiC substrates

The effects of self-assembling off-angles on the homoepitaxial lateral outward growth of single-crystal diamond

Vertical-substrate Epitaxial Growth of Single-Crystal Diamond by Microwave Plasma-Assisted Chemical Vapor Deposition

Epitaxial lateral growth of single-crystal diamond under high pressure by a plate-to-plate MPCVD

Surface Morphology and Microstructure Evolution of Single Crystal Diamond during Different Homoepitaxial Growth Stages

Relationship Between Basal Plane Dislocation Distribution and Local Basal Plane Bending in PVT-Grown 4H-SiC Crystals

High-Rate Growth and Nitrogen Distribution in Homoepitaxial Chemical Vapour Deposited Single-crystal Diamond

High-rate Growth of CVD Single-Crystal Diamond and Its Application

Physical bending of heteroepitaxial diamond grown on an Ir/MgO substrate

Recent advances in high-growth rate single-crystal CVD diamond

Fracture Strength and Toughness of Chemical-Vapor-deposited Polycrystalline Diamond Films