Abstract:In this work, the gate controllability of WSe2 channel with varying thickness from monolayer to ten‐layer is investigated, by fabricating van der Waals contacted WSe2 devices. The findings demonstrate negligible hysteresis and excellent subthreshold swing observed when utilizing WSe2 channel thicknesses ≥ five‐layer. However, by reducing the WSe2 channel thickness below the trilayer, the subthreshold swing deviates from the thermal limit. The pursuit of near‐ideal subthreshold swing (SS) ≈ 60 mV dec−1 is a primary driving force to realize the power‐efficient field‐effect transistors (FETs). This challenge is particularly pronounced in 2D material‐based FETs, where the presence of a large interface trap density (Dit) imposes limitations on electrostatic control, consequently escalating power consumption. In this study, the gate controllability of 2D FETs is systematically analyzed by fabricating pre‐patterned van der Waals (vdW)‐contacted p‐FETs, varying the WSe2 channel thickness from monolayer to ten‐layer. As a result, the channel thickness is optimized to achieve efficient gate controllability while minimizing Dit. The findings demonstrate negligible hysteresis and excellent subthreshold swing (SSmin) close to the thermal limit (≈60 mV dec−1), with a corresponding Dit of ≈1010 cm−2 eV−1, comparable to Dit values observed in state‐of‐the‐art Si transistors, when utilizing WSe2 channel thicknesses ≥ five‐layer. However, reducing the WSe2 channel thickness below the trilayer, SSmin (≈91 mV dec−1) deviates from the thermal limit, attributed to a comparatively higher Dit (≈1011 cm−2 eV−1), despite the still lower than values reported for surface‐contacted 2D transistors. Furthermore, all devices exhibit consistent p‐type characteristics, featuring a high ION/IOFF ratio, high mobility, and excellent electrical stability confirmed over several months.

Tapping the Performance of a Tungsten Disulfide Field-Effect Transistor with Deep Structure Optimization and Theoretical Simulation

High-Performance Wafer-Scale MoS2 Transistors Toward Practical Application

High Performance WSe2 Field-Effect Transistors via Controlled Formation of In-Plane Heterojunctions

High Performance Field-Effect Transistor Based on Multilayer Tungsten Disulfide

Wafer-scale Transferred Multilayer MoS2 for High Performance Field Effect Transistors

Ultrashort Channel Chemical Vapor Deposited Bilayer WS2 Field-Effect Transistors

High-Fidelity Transfer of 2D Semiconductors and Electrodes for Van Der Waals Devices

Performance Improvement in P-Type WS2 Field-Effect Transistors with 1T Phase Contacts

Electron Transport and Device Physics in Monolayer Transition-Metal Dichalcogenides

High‐Performance Monolayer WS2 Field‐Effect Transistors on High‐κ Dielectrics

Evolution Application of Two-Dimensional MoS2-Based Field-Effect Transistors

Enhanced Carrier Transport by Transition Metal Doping in WS2 Field Effect Transistors

High-Performance Contact-Doped WSe2 Transistors Using TaSe2 Electrodes.

Achieving Near‐Ideal Subthreshold Swing in P‐Type WSe2 Field‐Effect Transistors

Tunnel Field-Effect Transistors in 2D Transition Metal Dichalcogenide Materials

Simulation of 2D ReS2/WSe2 Based Complementary Field-Effect Transistors Towards 1 Nm Technology Node

Improvements in 2D p-type WSe2 transistors towards ultimate CMOS scaling

Atomistic Simulations of Device Physics in Monolayer Transition Metal Dichalcogenide Tunneling Transistors

Unipolar P-Type Monolayer WSe2 Field-Effect Transistors with High Current Density and Low Contact Resistance Enabled by Van Der Waals Contacts

Simulation of Thin-TFETs Using Transition Metal Dichalcogenides: Effect of Material Parameters, Gate Dielectric on Electrostatic Device Performance

Optimized Electrical Properties of P-Type Field-Effect Transistors Based on WSe2 Grown at Moderate Temperatures