Abstract:As an important component of the air-breathing combined precooling cycle engine of the hypersonic aircraft, the compact heat exchanger plays an important role in precooling the incoming air. However, the compact heat exchanger is easy to frosting during the precooling operation, which leads to an extremely unfavorable result, that is, the specific impulse and specific thrust of the engine significantly decrease. Therefore, in order to maintain the performance of the engine, some measures should be taken to defrosting the compact heat exchanger of the engine. In order to carried out the frosting and defrosting experiments on the compact heat exchanger that operating at relatively low altitudes, the frosting and defrosting performance of the compact heat exchanger are experimentally studied in the wind tunnel under the conditions of moderate airflow humidity value (6.4 g/kg), as well as the flow velocity and the temperature of the mainstream are 10 m/s and 50 °C, respectively. In the defrosting experiments, anhydrous methanol and anhydrous ethanol are sprayed into the mainstream as the defrosting solvents, respectively, and the mass ratios of anhydrous methanol to water and anhydrous ethanol to water are 0.75, 1.0 and 1.25. The experimental results indicate that for the frosting experiment, after coolant flows through the inside of the heat exchanger tube bundles, the frost layer quickly condenses on the outside of tube bundles. However, in the defrosting experiments, once a certain mass ratio of anhydrous methanol or anhydrous ethanol is sprayed into the main flow, the wall temperature of the heat exchanger tube bundles increases significantly, and the wall temperature is close to or higher than the freezing point of water. Furthermore, the defrosting effect and the heat transfer rate are obviously improved, and the pressure loss coefficient drops sharply. Through the analyzation of the defrosting experimental results, it is found that the defrosting performance of anhydrous methanol and anhydrous ethanol are obvious different, and the defrosting effect of anhydrous methanol is significantly higher than that of anhydrous ethanol with the same mass ratio. Within the range of experimental study parameters, for anhydrous methanol, the best defrosting performance can be obtained when the mass ratio is 1.0; and for anhydrous ethanol, the best defrosting effect can be realized when the mass ratio is 1.25. However, the defrosting performance of anhydrous ethanol with the mass ratio of 1.25 is still slightly lower than that of anhydrous methanol with the mass ratio of 0.75. Moreover, in order to achieve the best defrosting performance of the compact heat exchanger, the optimal mass ratio of anhydrous methanol to water may be in the range of between 1.0 and 1.25; and the optimal mass ratio of anhydrous ethanol to water should be greater than 1.25.

Effect of Different Plenum-Chamber Coefficients on the Frosting of Air-Cooler

An Experimental Study on the Air Side Heat Transfer Performance of the Perforated Fin-Tube Heat Exchangers under the Frosting Conditions

THE INFLUENCE OF NON-IDEAL EFFECTS OF ACTUATING MEDIUM ON THE PERFORMANCE OF A PLASTIC CRYOCOOLER

Temperature-gradient-enabled Prohibition of Condensation Frosting on Fin Surfaces

Numerical auxiliary study of charge-air cooler design

An experimental investigation of frosting characteristics considering edge effect for aperture plate lower surface affected by relative humidity

Effect of mixed hydrophilic and hydrophobic surface coatings on droplets freezing and subsequent frost growth during air forced convection channel flows

Experimental Study of Frost Formation on Cold Surfaces with Various Fin Layouts

Image-Analysis-Based Approach for Identification of Air Cooler Heat Transfer Degradation during Frosting Process

Performance Improvement of Microchannel Heat Exchangers with Modified Louver Fins under Frosting Conditions

A modeling study of spatial and temporal frost growth on the edge of windward fins for a tube-finned heat exchanger

Frost-Air Interface Characterization Under Natural Convection

Research on Air-Duct Optimization and Temperature Uniformity Analysis of Domestic Frost-Free Refrigerator-Freezer

Investigation on the performance coupling characteristics between a compound anti-frosting method and air source heat pump system

Experimental Study on the Frosting and Heat Transfer Performance of Three Rows of Variable Pitch Finned Coils

Dynamic frosting characteristics on cold flat surface in different air temperature and humidity conditions

Impacts of Initial Cooling Rate on Local Frosting Characteristics of Horizontal Cold Plate Surface with Edge Effect Considered

Experimental study on frost layer's thermal conductivity of cryogenic vertical plate under natural convection condition

Experimental study on the influence of airflow velocity on frosting and defrosting performance of compact precooler under actual air humidity condition

Review of restraint frost method on cold surface

Experimental studies on the frosting and defrosting performance of compact heat exchanger under moderate humidity condition