Abstract:Atomization of low-temperature fuel is encountered in extreme operating conditions of liquid propulsion systems such as cold start and high-altitude relight for aeroengines. Fuel temperature has a great impact on airblast spray characteristics by influencing fuel viscosity and thus the gas–liquid interaction, which raises the demand to clarify the temperature-dependent transition in near-nozzle breakup behavior and the corresponding droplet size distribution. A liquid-centered swirl coaxial injector is tested on the low-temperature swirl spray and combustion test rig at Zhejiang University, using 25 kHz high-speed digital off-axis holography. RP-3 aviation kerosene is atomized under ignition conditions at temperatures of 233, 253, and 301 K, fuel pressures of 0.03 and 0.69 MPa, and air pressure ranging from 0 to 4.0 kPa. Time-resolved near-nozzle dynamics suggest four types of elementary breakup processes: wavy-sheet breakup, pulsating breakup, membrane-type breakup, and nonaxisymmetric Rayleigh breakup. Each process alternately dominates the near field as fuel Reynolds number (Ref) and aerodynamic Weber number (Weg) decrease, corresponding to four primary breakup modes. A mode classification plot is summarized. Spray structures show an extended breakup length and reduced spray cone angle as fuel temperature (Tf) decreases. Increasing air pressure (Pg) promotes spray expansion at 0.03 MPa, but contracts spray cone at 0.69 MPa. Cross-sectional Sauter mean diameter (SMD) distribution indicates a solid-cone spray at 0.03 MPa and a hollow cone spray at 0.69 MPa. Lowering Tf will rise the SMD in the spray center at 0.03 MPa and transform the toroidal SMD distribution at 0.69 MPa into a solid one. Finally, a temperature-related SMD model is derived considering the exponential viscosity–temperature relationship, and a good fit with R2 > 0.95 is achieved. This research aims to deepen the understanding of the effects of low temperature on the transition of near-nozzle atomization characteristics for airblast sprays. Both spray visualization and SMD results provide reference for numerical simulations and near-nozzle spray modeling.

High-gravity deoxygenation of jet fuels using rotating packed bed

Large Eddy Simulations of Heat Transfer and Thermal Oxidative Coking of Aviation Kerosene in Vertical U-Tube at a Supercritical Pressure

Asymmetric Heating and Buoyancy Effects on Heat Transfer of Hydrocarbon Fuel in a Horizontal Square Channel at Supercritical Pressures

Single-step catalytic deoxygenation of palm feedstocks for the production of sustainable bio-jet fuel

Effects of Low Temperature on Near-Nozzle Breakup and Droplet Size Distribution in Airblast Kerosene Spray

Numerical Study of Fluid Flows and Heat Transfer of Aviation Kerosene with Consideration of Fuel Pyrolysis and Surface Coking at Supercritical Pressures

Performance of Rotating Packed Beds in Increasing Dissolved Oxygen in Water

Computational fluid dynamic simulation of fluid flow in a rotating packed bed

Deep Deoxidation of Water in a Miniaturized Annular Rotating Device: Experimental Investigation and Machine Learning Modeling

Liquid-solid mass transfer in a rotating packed bed reactor with structured foam packing

Gas-liquid Transport Behaviors and Mass Transfer Mechanism During Oxygen Dissolution and Evolution Processes in a Micropump

Investigation of Gas-Liquid Mass Transfer in the Fuel Scrubbing Inerting Process Using Mixed Inert Gas

Flow Pattern Effects on the Oxidation Deposition Rate of Aviation Kerosene

On promoted combustion stability of kerosene/ethanol blends at wide low temperatures: Fuel reactivity improvement and Leidenfrost effect suppression

Redirecting liquid momentum in rotating-packed-bed midway packing to enhance gas–liquid mass transfer: Modelling and application based on liquid-capture mechanism in end-effect zone

Fast Deoxygenation in a Miniaturized Annular Centrifugal Device

Combustion enhancement and soot reduction of kerosene-based fuel under engine-relevant conditions enabled by fuel reactivity modulation

Process intensification of reactive extraction for hydrogen peroxide production in a rotating packed bed reactor

Conversion of bio-jet fuel from palm kernel oil and its blending effect with jet A-1 fuel

A methodology for the analysis of distillation processes within rotating packed beds based on local temperature measurements

Computational fluid dynamic simulation of gas-liquid flow in rotating packed bed: A review