Abstract:Current-source inverter (CSI) is considered as a prospective solution for modern machine drives, for its higher reliability and superior harmonic suppression. The open-circuit fault-tolerant control for five-phase CSI-fed permanent magnet synchronous machine drive with pentagon winding connection is investigated. The switch open-circuit fault and winding open-circuit fault are studied. For the switch open fault, three cases are discussed including single-phase, adjacent two-phase, and nonadjacent two-phase faults. It is indicated that in pentagon circuit, despite the switch of fault phase is disabled, the corresponding phase winding is still connected in the end-to-end power circuit and contributes for torque generation. The new sets of coordinate transformation are proposed, and the mathematical modeling is presented. The fault-tolerant space vector modulation techniques are proposed based on the reconstructed vector planes. In addition, the single winding open fault is studied, which is a specific fault case and breaks off the closed pentagon connection. An important conclusion is derived that the pentagon winding connected CSI gains inherent fault-tolerant capability against the single winding open circuit. The control algorithm even does not need to be switched during this typical fault. Experiments are performed on verifying the proposed schemes.

Modeling and Control of Permanent-Magnet Synchronous Generators Under Open-Switch Converter Faults

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

A Sinusoidal Current Control Method for SPMSM Considering Uneven Demagnetization Fault

Fault-Tolerant Operation for Single-Phase Open Circuit of Dual-Armature Flux-Switching Permanent Magnet Machine by Connecting Neutral Points

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Fault-Tolerant Control Technique of Permanent Magnet Synchronous Generator Based on Open Winding Configuration

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Modeling and Control for Open-Winding PMSM Under Open-Phase Fault Based on New Coordinate Transformations

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Variable speed control of a 5-phase permanent magnet synchronous generator including voltage and current limits in healthy and open-circuited modes

Harmonic Model and Remedy Strategy of Multiphase PM Motor under Open-Circuit Fault

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Open-fault diagnosis and tolerant control of a dual inverter fed open-end winding interior permanent magnet synchronous motor

Fault-tolerant Control Strategy for Five-phase Permanent Magnetic Synchronous Motor under Single Phase Open-circuit Fault Condition

Multiple Open-Switch Fault Diagnosis for Five-Phase Permanent Magnet Machine Utilizing Currents in Stationary Reference Frame

Control Strategy for Four Phase Open Faults of Dual Three-Phase PMSG

Fault-Tolerant Control of Modular Permanent Magnet Synchronous Motor under Open-Circuit Faults.

Open-Circuit Fault-Tolerant Control of Five-Phase PM Machine Based on Reconfiguring Maximum Round Magnetomotive Force.

Open-Circuit Fault-Tolerant Control for Pentagon Winding Connected Five-Phase Current-Source Inverter Based PMSM Drives