Plume ejection and product in laser cleaning of ferrite paint

Chen Zou,Shusen Zhao,Haijun Yu,Zhiyan Zhang,Han liang,Lu Jiang,Jie Xu,Xuechun Lin,Xubao Wang

DOI: https://doi.org/10.1016/j.optlastec.2023.109733

2023-06-26

Abstract:Ferrite paint are commonly used on the surface of aluminum alloys. It contains metal oxide particles, significantly affecting laser paint removal when a nanosecond pulsed laser was used to clean the ferrite paint. In this paper, we experimentally investigate and analyze the plume ejection characteristics and the product during the laser cleaning of the paint. Driven by ablative gas recoil pressure, the ferrite paint was vaporized by the laser pulse into a mixture of molten droplets, resin residual particles, and carbides, and they were then ejected from the laser scanning area with the plume to form a black spatter powder on the cleaned surface. A physical model for calculating the ejection angle of the laser-cleaning plume is established. The results show that the thermal diffusion rate of paint and substrate, laser pulse duration, and laser scanning speed determine the plume ejection angle. Optimizing laser defocus distance and lap rate could significantly reduce surface spatter and improve cleaning quality. Furthermore, through the analysis of XPS, we found that the valence state of the residual ferrite paint changes after the laser cleaning and may affect the residual paint's microwave-absorbing performance. Therefore, removing the ferrite paint layer completely and then re-spray rather than only removing a certain paint depth is necessary.

optics,physics, applied