Abstract:With high reversible capacities of more than 200 mAh/g, Ni-rich layered oxides Li[NixCoyMn1−x−y]O2 (x ≥ 0.6) serve as the most promising cathode materials for lithium-ion batteries (LIBs). However, the anisotropic lattice volume changes linked to their α-NaFeO2 structured crystal grains bring about poor cycle performances for conventionally produced NCM materials. To deal with these issue, single-crystal pm-sized LiNi0.8Co0.1Mn0.1O2 rods was synthesized by a hydrothermal method. Compared with conventional synthesis methods, these LiNi0.8Co0.1Mn0.1O2 rods were calcined at a low temperature with excessive lithium sources, which not only reduces the sintering temperature but also ensures the mono-dispersed micrometer-scaled particle distribution. When used as the cathode material for LIBs, the as-prepared LiNi0.8Co0.1Mn0.1O2, with ordered layered-structure and low degree of cation mixing, shows excellent electrochemical performances. When sintered at 750 °C with 50% Li-excess, the cathode material delivered an initial discharge capacity of 226.9 mAh/g with Coulombic efficiency of 91.2% at 0.1 C (1 C = 200 mA/g) in the voltage range of 2.8–4.3 V. When charge-discharged at 1 C for 100 cycles, discharge capacity of 178.1 mAh/g with the capacity retention of 95.1% are still obtained. The cycling stability at high cut-off voltage is also outstanding. These superior electrochemical properties should be related to the monodispersed micron scaled morphology which not only decreases the contact area between electrode and electrolyte but also mitigates the formation of microcracks. This low-temperature strategy of synthesizing single-crystal LiNi0.8Co0.1Mn0.1O2 rods should be able to provide a feasible method for synthesizing other single-crystal Ni-rich cathode materials with excellent electrochemical performances for LIB.

Kinetic Control Synthesis of Low-Strain Disordered Micro-Nano High Voltage Spinel Cathodes with Exposed {111} Facets

Ordered LiNi0.5Mn1.5O4 Cathode in Bis(fluorosulfonyl)imide-Based Ionic Liquid Electrolyte: Importance of the Cathode-Electrolyte Interphase

Inhibit the strain accumulation for 5 V spinel cathode by mitigating the phase separation during high voltage stage

Inhibit the Strain Accumulation for 5V Spinel Cathode by Mitigating the Phase Separation During High Voltage Stage

Both Interface and Bulk Stable LiNi 0.5 Mn 1.5 O 4 Cathodes for High-Energy Li-Ion Batteries

Crystallographic‐Site‐Specific Structural Engineering Enables Extraordinary Electrochemical Performance of High‐Voltage LiNi 0.5 Mn 1.5 O 4 Spinel Cathodes for Lithium‐Ion Batteries

High‐Voltage Spinel Cathode Materials: Navigating the Structural Evolution for Lithium‐Ion Batteries

Overlithiation-driven structural regulation of lithium nickel manganese oxide for high-performance battery cathode

Low-temperature strategy to synthesize single-crystal LiNi0.8Co0.1Mn0.1O2 with enhanced cycling performances as cathode material for lithium-ion batteries

Synthetic Control of Kinetic Reaction Pathway and Cationic Ordering in High‐Ni Layered Oxide Cathodes

A long cycle-life high-voltage spinel lithium-ion battery electrode achieved by site-selective doping.

Surface spinel reconstruction to suppress detrimental phase transition for stable LiNi0.8Co0.1Mn0.1O2 cathodes

Optimized Morphology and Tuning the Mn3+ Content of LiNi0.5Mn1.5O4 Cathode Material for Li-Ion Batteries

General Synthesis of Single‐Crystal Spinel Cathodes with the Tailored Orientation of Exposed Crystal Planes for Advanced Lithium‐Ion Batteries

Boosting cycling stability by regulating surface oxygen vacancies of LNMO by rapid calcination

Crystalline geometry engineering towards high-energy spinel cathode for lithium-ion batteries

Insight into the cation migration and surface structural evolution of spinel LiNi0.5Mn1.5O4 cathode material for lithium-ion batteries

N-doped engineering of a high-voltage LiNi0.5Mn1.5O4 cathode with superior cycling capability for wide temperature lithium-ion batteries

Submicron single-crystalline LiNi0.5Mn1.5O4 cathode with modulated Mn3+ content enabling high capacity and fast lithium-ion kinetics

One-step calcination synthesis of interface-coherent crystallized and surface-passivated LiNi0.5Mn1.5O4 for high-voltage lithium-ion battery

Enhanced High Voltage Stability of Spinel‐Type Structured LiNi 0.5 Mn 1.5 O 4 Electrodes: Targeted Octahedral Crystal Site Modification