Abstract:Recent decades have seen a growing concern about ever-increasing green house gas (GHG) emissions and depletion of fossil fuels. Polygeneration, a multi-input multi-output energy system, provides huge opportunities to tackle these problems due to its superior performances over conventional energy systems in terms of energy conversion efficiency and GHG emissions. Many approaches have been made in process design and analysis of polygeneration energy systems, but most of them focus on using coal gasification as the only way to provide gas for downstream utilization. Coke oven gas, another gas source with huge capacity, however, has not received enough attention in polygeneration process design, and researches in this field are still rather limited. In this paper, we present a dual-gas sourced polygeneration process design which uses both gasification gas and coke oven gas and produces methanol, dimethyl ether (DME), and dimethyl carbonate (DMC) in an integrated catalysis procedure. Gasification gas and coke oven gas are converted to synthesis gas, or syngas, via a catalytic reforming procedure, where the ratio between carbon monoxide and hydrogen in the syngas is carefully adjusted according to specific requirements of downstream chemical synthesis reactions. An integrated catalysis procedure follows, where DME is synthesized from the fresh syngas first, unconverted syngas is then sent to a methanol synthesis unit to produce methanol, and part of the methanol is further converted to DMC in a DMC synthesis unit. Based on the proposed process design, an exergoeconomic analysis and an exergy cost distribution diagram are presented, from which the production cost of a product over each functional block of the process can be easily obtained. Analysis results show that the largest exergy loss occurs in an exothermic reformer, accounting 60.4 percent of the total exergy loss. The exergy cost distribution diagram indicates that DMC has the highest exergy cost, followed by DME and methanol, and it is economically favorable to use the exhaust gas from the chemical synthesis block for power generation.

Exergy Analysis and Modeling of Pilot-Scale Pyrolysis for Magnesium Oxide Preparation from Salt Lake Bischofite Industrial Waste

Co-pyrolysis of saw dust and oily sludge with waste-heat utilization of steel slag on rotary kiln simulated engineering practice

Simulation and exergoeconomic analysis of a dual-gas sourced polygeneration process with integrated methanol/DME/DMC catalytic synthesis

Efficient Treatment of Oily Sludge Via Fast Microwave-Assisted Pyrolysis, Followed by Thermal Plasma Vitrification.

Exergy analysis and CO2 emission evaluation for steam methane reforming

Numerical simulation of complex thermal decomposition processes in pyrolysis furnace for recycling solid waste Mg(NO3)2.2H2O

Rotary hearth furnace for steel solid waste recycling: Mathematical modeling and surrogate-based optimization using industrial-scale yearly operational data

Technical and economic feasibility analysis of recovery flue gas desulphurization with magnesium oxide

Parameters effect and optimization on calciner for treating magnesium salt based on computational fluid dynamics

Exploring multistep bischofite waste pyrolysis: insights from advanced kinetic analysis and thermogravimetric techniques

Advanced exergoenvironmental analysis of the oil shale retorting process with SJ-type rectangular retort

Exergy sustainability analysis of biomass gasification: a critical review

Deposition of MgO film by pyrolysis of bischofite through RF thermal plasma process

Process Modeling and Exergy Analysis for a Typical VOC Thermal Conversion Plant

Kinetic Analysis of Landfill Stale Garbage (LSG) Pyrolysis and Combustion Behaviour Using Thermogravimetry Coupled MS and FTIR Technique

Exergy analysis of an integrated solid oxide electrolysis cell-methanation reactor for renewable energy storage

Kinetic research of red mud waste oxidative pyrolysis and comparison under different atmospheres

Development of Numerical Analysis Model for New Magnesium Electrolysis Process Using COMSOL

Energy and exergy analysis of MSW-based IGCC power/polygeneration systems

A dual-gas sourced integrated methanol/DME/DMC catalysis approach to polygeneration energy systems design and an exergoeconomic analysis

Kinetic and thermodynamic analysis of pyrolysis of oily cold rolling mill sludge of steel industry under non-isothermal conditions