Abstract:Abrasive wear can have a detrimental effect on machinery, especially in the mining and construction industries. To prolong machinery lifetime and cut down energy consumption, a thorough understanding of abrasive wear is essential: surface topography measurement and interpretation (including form, waviness, and roughness) are vitally important. However, the potentially crucial influence of surface topography intricacies on tribological behavior has been obscured since roughness and waviness are considered simple scalar quantities in most cases (e.g., roughness R a and waviness W t ). In this work, the complete waviness profile of the sliding track was used to shed light on the influence of surface topography on abrasive wear. Bearing steel (100Cr6, AISI 52100) pins and disks were tribologically tested in a flat-on-flat contact with Al 2 O 3 -based slurries as interfacial medium. Using slurries with two different particle sizes, 5 and 13 μm, we found that friction fluctuates only with small abrasive particles (5-μm slurry) and relatively low waviness disks. It was found that even small surface deviations (albeit minimized and controlled for) can significantly increase the friction coefficient—up to 91%. Remarkably, not only are frictional fluctuations strongly correlated with the disk's initial waviness profile, but these small fluctuations correlate with unevenly distributed high wear. These findings enhance our understanding of the friction wear structure and provide the basis for exploring how surfaces can be optimized for better tribological performance.

Negative thermal expansion induced suppression of wear in dry sliding friction

Negative differential friction coefficients of two-dimensional commensurate contacts dominated by electronic phase transition

Analysis of the dissipation processes of external input energy in conditions of anomalous low friction and wear

Influence of the Adhesion Force and Strain Hardening Coefficient of the Material on the Rate of Adhesive Wear in a Dry Tangential Frictional Contact

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Negative or Positive? Loading Area Dependent Correlation Between Friction and Normal Load in Structural Superlubricity

Waviness Affects Friction and Abrasive Wear

3D-printed biomimetic surface structures with abnormal friction properties

Temperature Rise in Frictional Sliding Contact of Elastic–Plastic Solids with Fractal Surface

Positive-Negative Tunable Coefficients of Friction in Superlubric Contacts

Temperature dependence of energy dissipation during nanoscale wear of AISI 304L stainless steel

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Efficiency of surface texturing in the reducing of wear for tests starting with initial point contact

Does laser surface texturing really have a negative impact on the fatigue lifetime of mechanical components?

Wear Rate, Frictional Temperature, and Energy Consumption of Steel 52100 with Different Microstructures During Sliding

Friction and wear characteristics modification via laser surface textured grooves

High temperature negative wear behaviour of VN/Ag composites induced by expansive oxidation reaction

Mechanisms of near-surface structural evolution in nanocrystalline materials during sliding contact

Adhesion-dependent Negative Friction Coefficient on Chemically Modified Graphite at the Nanoscale

Chemifriction and Superlubricity: Friends or Foes?

Molecular Origin of Friction