Abstract:The influence of aerosol concentration on the charge per particle is investigated in post-DC corona diffusion chargers for particle diameter between 10 nm and 1 µm. Particles are charged as they pass through the charger volume by collection of ions; the ion concentration decreases along the same path due to unipolar space charge repulsion and collection on walls. With crossflow of ions and aerosols, the final mean charge per particle decreases by up to one order of magnitude with increasing aerosol concentration from 109 to 1011 m−3. The evolution of the ion density profile along particle trajectories with aerosol concentration is shown to be due to the consumption of ions by aerosol charging and to ion dispersion by unipolar space charge repulsion including ions and charged particles. Both are investigated using a simplified 1.5 D model with axial symmetry and homogeneous mixing of ions and aerosols. It is shown that, for a given operating condition, the aerosol space charge is responsible for the modification of the spatial ion distribution and the related lower Ni × τ and charge per particle reported at higher aerosol concentration. From calculations, we define the maximal aerosol concentration to keep the mean charge per particle unaffected by aerosol space charge in the optimal case of homogeneous mixing of ion and aerosol. Finally, the comparison of different ion-aerosol mixing conditions highlights that an axial symmetry of the charger reduces the influence of aerosol space charge. This effect of aerosol concentration on the particle charge is critical for aerosol chargers devoted to electric mobility selection for size measurements or focused electro-deposition, as well as for concentration measurements as performed using emerging low cost sensors based on corona chargers. Copyright © 2021 American Association for Aerosol Research

A low-cost and miniature aerosol charger using americium-241

Development the Miniaturized AMS System and Its Analysis Technique

High-Resolution Mobility and Mass Spectrometry of Negative Ions Produced in a 241am Aerosol Charger

Post-corona unipolar chargers with tuneable aerosol size-charge relations: Parameters affecting ion dispersion and particle trajectories for charger designs

Electrostatic Precipitation of Fine Particles with a Bipolar Pre-Charger

Aerosol Charge Fractions Downstream of Six Bipolar Chargers: Effects of Ion Source, Source Activity, and Flowrate

Maximizing the Singly Charged Fraction of Sub-micrometer Particles Using a Unipolar Charger

Aerosol Charging State at an Urban Site: New Analytical Approach and Implications for Ion-Induced Nucleation

Measuring Size Distributions of Atmospheric Aerosols Using Natural Air Ions

Effect of aerosol concentration on post-corona unipolar diffusion charging: Ion density retro-controlled by aerosol space charge versus geometry of ion-aerosol mixing

Method of measuring charge distribution of nanosized aerosols

A Portable Electrical Analyzer for Size Distribution Measurement of Submicron Aerosols

Development of a Novel Electrostatic-Based Bioaerosol Sampler

Improving the Performance of Portable Aerosol Size Spectrometers for Building Dense Monitoring Networks

A Miniature Aerosol Sensor for Detecting Polydisperse Airborne Ultrafine Particles

Simulation of Gas Discharge in a Needle-to-Plane Geometry with Hundreds of Micrometers Gap and Its Enlightenment for Direct Charging of Aerosol Particles

A Low-Cost Demountable Direct Injection High-Efficiency Nebulizer for Inductively Coupled Plasma Mass Spectrometry

Particle charge-size distribution measurement using a differential mobility analyzer and an electrical low pressure impactor

A Soft X-ray Unipolar Charger for Ultrafine Particles

Electrical Mobility Spectrometer Using a Diethylene Glycol Condensation Particle Counter for Measurement of Aerosol Size Distributions Down to 1 Nm

An Ionization-Based Aerosol Sensor and Its Performance Study