Abstract:Suspension plasma spray is a promising technology for surface coatings. In this work, a comprehensive numerical model was developed to investigate the multiphase flow of suspension droplets and nanoparticles in direct-current (DC) plasma spraying. A three-dimensional computational model was developed to describe the plasma jet flow fields coupled with the axial injection of suspension droplets in which the zirconia micro- and nanoparticles were dispersed. The suspension droplets were tracked using Lagrangian coordinates, considering particle heating, melting, and evaporation. After evaporation of the solvent surrounding the particle, the nanoparticles were discharged into the plasma flow. In addition to the viscous force exerted by the flow on the micrometer-sized particles, the Brownian force and the Saffman lift force were taken into account. The effects of the noncontinuum on particle momentum transfer and evaporation on heat transfer were also considered. The numerical predictions of gas flow temperature were compared with experimental data and numerical data obtained with a different computational fluid dynamics code. The agreement was reasonable. The trajectories, velocity, and temperature of nanoparticles were calculated, and compared with those of microparticles. The results showed that the Brownian force plays a major role in acceleration and heating of nanoparticles. Compared with the conventional plasma spray process with micrometer-sized feedstock, the nanoparticles in suspension plasma spraying were found to have a wider spatial distribution and higher temperature. The effects of operating parameters, such as the power input to the plasma gas and plasma gas composition, on the gas velocity and temperature were investigated. The parameters that have a significant effect on the heat and momentum transfer to the particles injected in the plasma jet were identified.

Simulation of Gas Discharge in a Needle-to-Plane Geometry with Hundreds of Micrometers Gap and Its Enlightenment for Direct Charging of Aerosol Particles

Self-sustaining discharges in needle-to-plane geometry with hundreds of microns electrode gaps

Simulation of Positive Surface Discharge in C4F7N Gas Mixture

Simulation of Effervescent Atomization and Nanoparticle Characteristics in Radio Frequency Suspension Plasma Spray

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Numerical Simulation of Streamer Discharge with Different Electrode Shapes in C4F7N

Charging efficiency of nanoparticles in needle-to-plate chargers with micro discharge gaps

Study on Gas Discharge at Atmospheric Air by Numerical Method

Repetitively Pulsed Discharges Ignited in Microchannels Between Two Nonequally Broad Planar Electrodes and Their Charging for Nanoscale Aerosol Particles

Simulation of Electrospray Emission Processes for Highly Conductive Liquids

An Ionization-Based Aerosol Sensor and Its Performance Study

Particle-in-cell and Monte Carlo Collision Simulations of the Cathode Sheath in an Atmospheric Direct-Current Arc Discharge

Numerical simulation of charging up, accumulation of space charge and formation of discharges

Numerical Simulation of the Negative Streamer Propagation Initiated by a Free Metallic Particle in N2/O2 Mixtures under Non-Uniform Field

Study of the electric field in a diffuse nanosecond positive ionization wave generated in a pin-to-plane geometry in atmospheric pressure air

Particle-in-cell simulations on the initial phase of a single gap gas discharge

Experimental and 2D fluid simulation of a streamer discharge in air over a water surface

Transmission of Charged Nanoparticles Through the DMA Adverse Axial Electric Field and Its Improvement

Simulation of PMMA powder flow electrification using a new charging model based on single-particle experiments

Simulation of electrostatic particulate matter sensor regeneration based on the particulate deposition patterns

Numerical simulation of pulsed wire discharge for nano-powder production