Abstract:Nanoscale mechanical resonator-based nanoelectromechanical systems have been reported with ultrahigh sensitivity, which are normally acquired from an ultravacuum environment at cryostat temperature. To facilitate their practical applications for gas sensing or bio-detection, it is critical to understand how the fluid (gas or liquid) environment will impact the resonance behaviors of the nanoresonator. This work reports a first-time comprehensive investigation on the influence of the N-2 gaseous environment on the resonance properties of carbon nanotube (CNT)-based mechanical resonator, through a combination of grand canonical Monte Carlo and large-scale molecular dynamics simulations. It is shown that the gaseous environment exerts a significant effect on the resonance properties of the CNT resonator through a dynamic desorption and readsorption process. Under the temperature of 100 K and the pressure of 1 bar, the displacement amplitude of the CNT resonator is found to experience a sharp reduction of about 82% within the first 90 ps vibration in the N-2 gaseous environment. Further, a large initial excitation is found to result in smaller adsorption and a reduced damping effect. For instance, when the excitation velocity amplitude increases from 2 to 8 angstrom/ps, the damping ratio shows more than 40% reduction. It is found that higher pressure leads to a smaller resonance frequency and enhanced damping effect, while higher temperature induces an increase in the resonance frequency but a decrease in the damping ratio. This work shows that the gaseous environment has a marked impact on the vibrational properties of nanoresonators, which should shed light on the application of mechanical nanoresonators in a fluid environment.

Miniature vacuum sensor based on gas adsorptions from carbon nanotube field emitters

A vacuum sensor using field emitters made by multiwalled carbon nanotube yarns

A Miniaturized Ionization Vacuum Sensor Based on Thermionic Electron Emission From Carbon Nanotubes

A MEMS-Type Hot-cathode Ionization Gauge With Carbon Nanotube-based Electron Emitters

A Novel Gas-Ionization Sensor Based on Aligned Multi-Walled Carbon Nanotubes

Field emission energy distribution studies of single multi-walled carbon nanotube emitter with gas adsorptions

Study of gas sensor with carbon nanotube film on the substrate of porous silicon

A Cylindrical Triode Ultrahigh Vacuum Ionization Gauge with a Carbon Nanotube Cathode

Improved Field Emission Properties of MgO‐nanoparticle‐doped Carbon Nanotube Films and Their Application in Miniature Vacuum Gauges

Vacuum Measurement Based on Field Emission of CNT Yarn

An ultracompact refractive index gas-sensor based on photonic crystal microcavity

How Gaseous Environment Influences a Carbon Nanotube-Based Mechanical Resonator

Progress in Carbon Nanotube Gas Sensor Research

MEMS-based Microelectrode System Incorporating Carbon Nanotubes for Ionization Gas Sensing

A Vacuum Transistor Based on Field-Assisted Thermionic Emission from a Multiwalled Carbon Nanotube

A Sensitivity Enhanced Gas Sensor Based on Carbon Nanotubes Around Microfiber

Toward Practical Gas Sensing with Rapid Recovery Semiconducting Carbon Nanotube Film Sensors

Ionization Gas Sensing in A Microelectrode System with Carbon Nanotubes

Study on Carbon Nanotubes Based Field-Effect DMMP Gas Sensors

Miniature Cold Cathode Ionization Gauge Based on Composite Films of Carbon Nanotubes and Mgo Nanoparticles

Novel Gas Ionization Sensors Using Carbon Nanotubes