Selenate Reduction Mediated by Underpotentially Deposited Cu on the Low Index Faces of Au in Aqueous Perchloric Acid

Jonathan Strobl,Saurabh Pathak,Daniel Scherson

DOI: https://doi.org/10.1016/j.electacta.2024.144298

IF: 6.6

2024-04-21

Electrochimica Acta

Abstract:Underpotential deposited Cu on the low index faces of single crystal Au electrodes has been found to promote the reduction of selenate, SeO42−(aq), in 0.1 M HClO 4 solutions, a behavior analogous to that reported earlier in our laboratory for polycrystalline Au (Strobl et al. J. Electrochem. Soc. 2016, 163 (13), H1066). Sequential potential step-linear scan voltammetry data collected for Au(111) film electrodes in solutions containing Cu 2+ (aq) in the μM range afforded evidence that the onset for the electrocatalytic activity occurs for Cu(UPD) coverages, θ Cu ≈ 0.18, the same value at which complementary microgravimetric data displayed a clear increase in mass. On this basis, a reaction mechanism has been proposed involving the initial reversible formation of an adsorbed adduct, we denote as Cu| SeO42−(ads), followed by a first order irreversible reduction to yield a yet to be identified species, which we denote as Cu|Se(ads), as the rate determining step. Support for this reaction scheme was obtained from numerical solutions of the coupled differential equations that govern the time evolution of Cu| SeO4−(ads) and Cu|Se(ads), yielding best agreement with the experimental data for values of the equilibrium constant for adduct formation and the adduct reduction rate constant of 2.5 × 10 6 cm 3 mol −1 , and 9.1 × 10 −3 s −1 , respectively. This unique electrocatalytic effect has been attributed to a shift in the potential of zero charge of the bare Au substrates induced by Cu(UPD), which promotes the adsorption of HSeO4−(aq) at potentials more negative than those found for the bare substrates, allowing access to overpotentials high enough for its activation and further reduction to ensue.

electrochemistry