Abstract:A method for speed and rotor position estimation of a brushless dc motor (BLDCM) is presented in this paper. An extended Kalman filter (EKF) is employed to estimate the motor state variables by only using measurements of the stator line voltages and currents. When applying the EKF, it was necessary to solve some specific problems related to the voltage and current waveforms of the BLDCM. During the estimation procedure, the voltage- and current-measuring signals are not filtered, which is otherwise usually done when applying similar methods. The voltage average value during the sampling interval is obtained by combining measurements and calculations, owing to the application of the predictive current controller which is based on the mathematical model of motor. Two variants of the estimation algorithm are considered: 1) speed and rotor position are estimated with constant motor parameters and 2) the stator resistance is estimated simultaneously with motor state variables. In order to verify the estimation results, the laboratory setup has been constructed using a motor with ratings of 1.5 kW, 2000 r/min, fed by an insulated gate bipolar transistor inverter. The speed and current controls, as well as the estimation algorithm, have been implemented by a digital signal processor (TMS320C50). The experimental results show that is possible to estimate the speed and rotor position of the BLDCM with sufficient accuracy in both steady-state and dynamic operation. Introducing the estimation of the stator resistance, the speed estimation accuracy is increased, particularly at low speeds. At the end of the paper, the characteristics of the sensorless drive are analyzed. A sensorless speed control system has been achieved with maximum steady-state error between reference and actual motor speed of ±1% at speeds above 5% of the rated value.

Convergence analysis of the modified adaptive extended Kalman filter for the parameter estimation of a brushless DC motor

Steady Performance Analysis on Single-Phase Brushless DC Motor

Adaptive Torque Control of Disturbed Brushless Direct Current Motor Based on Internal Model Principle

Robust Adaptive Speed Control of Disturbed Brushless Direct Current Motor

Parameter Observability Analysis of Interior Permanent Magnet Synchronous Motor and Online Parameter Identification Based on Adaptive Extended Kalman Filter

Online Parameter Identification for Surface-mounted Magnet Synchronous Motors Based on Adaptive RBF Neural Network

Design and implementation of the extended Kalman filter for the speed and rotor position estimation of brushless DC motor

Adaptive Rotor Flux Estimation and Parameter Identification for Induction Motor

Adaptive Flux Estimation and Parameters Identification of Induction Motors Based on Model Reference Approach

Sensorless Control Method Of Pmsm Based On Extended Kalman Filter

Full Parameter Estimation for Permanent Magnet Synchronous Motors.

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

Application of Adaptive Observer to Sensorless Induction Motor Via Parameter-Dependent Transformation

Detection Technology of Rotor Position and Speed of BLDCM Based on MEKF

Speed Estimation Method of Linear Motor Extended Kalman Filter Based on Attenuation Memory

Speed and rotor position estimation for sensorless brushless DC motor drive based on particle filter

Compensation of Current Sensor Faults in Vector-Controlled Induction Motor Drive Using Extended Kalman Filters

Adaptive Backstepping Control of Electro Hydrostatic Actuator with Improved Parameter Estimation

Torque Estimation using Kalman Filter and Extended Kalman Filter Algorithms for a sensorless Direct Torque Controlled BLDC Motor drive: A Comparative Study

Intelligent Sensor Based Bayesian Neural Network for Combined Parameters and States Estimation of a Brushed DC Motor

High Performance PMSM Control System Based on Extended Kalman Filter