Abstract:Barium titanate (BaTiO3, hereafter BT) is an established ferroelectric material first discovered in the 1940s and still widely used because of its well-balanced ferroelectricity, piezoelectricity, and dielectric constant. In addition, BT does not contain any toxic elements. Therefore, it is considered to be an eco-friendly material, which has attracted considerable interest as a replacement for lead zirconate titanate (PZT). However, bulk BT loses its ferroelectricity at approximately 130 °C, thus, it cannot be used at high temperatures. Because of the growing demand for high-temperature ferroelectric materials, it is important to enhance the thermal stability of ferroelectricity in BT. In previous studies, strain originating from the lattice mismatch at hetero-interfaces has been used. However, the sample preparation in this approach requires complicated and expensive physical processes, which are undesirable for practical applications. In this study, we propose a chemical synthesis of a porous material as an alternative means of introducing strain. We synthesized a porous BT thin film using a surfactant-assisted sol-gel method, in which self-assembled amphipathic surfactant micelles were used as an organic template. Through a series of studies, we clarified that the introduction of pores had a similar effect on distorting the BT crystal lattice, to that of a hetero-interface, leading to the enhancement and stabilization of ferroelectricity. Owing to its simplicity and cost effectiveness, this fabrication process has considerable advantages over conventional methods.

Chemical preparation of ferroelectric mesoporous barium titanate thin films: drastic enhancement of Curie temperature induced by mesopore-derived strain.

Chemical Synthesis of Porous Barium Titanate Thin Film and Thermal Stabilization of Ferroelectric Phase by Porosity-Induced Strain

Sol‐Gel Routes to Nanostructured Patterned Ferroelectric Thin Films with Novel Electronic and Optical Functions

Low-temperature synthesis of barium titanate thin films by nanoparticles electrophoretic deposition

Giant Electrocaloric Effect in Ferroelectric Ultrathin Films at Room Temperature Mediated by Flexoelectric Effect and Work Function

In Situ Preparation Of High Dielectric Constant, Low-Loss Ferroelectric Batio3 Films On Si At 500 Degrees C

Giant Electrocaloric Effect in Ferroelectric Nanotubes Near Room Temperature

Controlling of lattice strains for crack-free and strong ferroelectric barium titanate films by post-thermal treatment

Chemical-Pressure-Modulated BaTiO3 Thin Films with Large Spontaneous Polarization and High Curie Temperature

Crystallization, phase evolution and ferroelectric properties of sol-gel-synthesized Ba(Ti0.8Zr0.2)O3-x(Ba 0.7Ca0.3)TiO3 thin films

Preparation and surface characteristics of nanocrystal barium titanate and barium ferrite composite films

Structure and Ferroelectric Properties of Barium Titanate Films Synthesized by Sol–gel Method

Chemical Solution Processing and Properties of (bi,nd)(4)ti3o12 Ferroelectric Thin Films

Synthesis and Microstructure of Barium Bismuth Titanate Thin Films Using a Sol-Gel Technique

Tuning Ferroelectric Properties of Barium Titanate by Lateral Strain: A Molecular Dynamics Simulation Study

Preparations and Dielectric Properties of Ba0.80Sr0.20TiO3/PbO–B2O3 Thick Films

Large electric field-induced strain and antiferroelectric behavior in (1-x)(Na0.5Bi0.5)TiO3-x BaTiO3 ceramics

Preparation and Dielectric Properties of Cerium and Manganese Codoped Ba0.6sr0.4tio3 Ferroelectric Films

Low-temperature Preparation of BaTiO 3 Thin Film by MOD and Hydrothermal Treatment

Preparation And Microwave Properties Of Co- And Ti-Doped Barium Ferrite By Citrate Sol-Gel Process

Enhancement of the electrocaloric effect in the 0.4BCZT-0.6BTSn ceramic synthesized by sol-gel route