Abstract:Ball screw has become a key functional component commonly used in actuators of high-end machine tools because of its high transmission efficiency, low environmental impact, and strong universality of working conditions. For the high-precision ball screw, the proper and constant preload is the premise to maintain the transmission accuracy and reliable dynamic characteristics of the ball screw. The direct measurement of the preload is difficult to be achieved. Usually, the preload of the ball screw is indirectly determined by the friction torque of the ball screw under no-load condition. In previous studies, the influence of lubrication on friction torque of the ball screw was not considered, and the influence of operating conditions on performance of lubricant was ignored, and the influence of contact elastic hysteresis effect and the sliding friction effect was not considered, which seriously affected the modeling accuracy of friction torque for the ball screw. Therefore, on the basis of considering the contact elastic hysteresis friction and the sliding friction of the ball screw in the paper, a calculation model of friction torque for the ball screw based on the coupling of the ball load distribution and the thermal elastohydrodynamic lubrication is proposed. The mechanism of different friction terms on the friction torque of the ball screw is analyzed, and the coupling relationship among preload, rotational speed, and friction torque is established. The experimental results show that the proposed method, which the ball load distribution, the thermal elastohydrodynamic lubrication, the elastic hysteresis, and the sliding friction are comprehensively considered, has a good reference significance for improving the internal preload and predicting the precision degradation of the ball screw.

Study on interface non-uniform slip of combined rotor considering real preload distribution

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Mass-eccentricity nonlinear evolution mechanism of combined rotor in fretting slip process

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

Measured and investigated nonlinear dynamics parameters on bolted flange joints of combined rotor

Lubrication and stability analysis of nonlinear rotor-bearing system

Experimental Investigation on Friction Characteristics of Ultrasonic Motor

Numerical Simulation of Overturning Phenomenon of Axial Piston Pump Slipper Pair

EXPERIMENTAL VERIFICATION OF SLIPPER SPINNING MOTION IN AXIAL PISTON PUMPS

Experimental Investigations of the Slipper Spin in an Axial Piston Pump

Dynamic Behavior of Vertical Rotor with Slip Support Pairs

Static and Dynamic Stress of the Combined Rotor with Curvic Couplings Considering the Rough Three-Dimensional Interface at Extreme Operating Conditions

Calculation and analysis of wet clutch sliding torque based on fluid-solid coupling dynamic behavior

Simulation and Experimental Study of Engagement Process with Groove Consideration

Investigation of Non-Uniform Preload on the Static and Rotational Performances for Spindle Bearing System

A modeling method for predicting friction torque of the preload double-nut ball screw based on thermal elastohydrodynamic lubrication

Coupling dynamics of pedestal looseness and impact-rub for rotor system with nonlinear support

Experimental investigation of thermal characteristics of rotor-bearing system under non-uniform preload

A Study Of The Film Formation For A Rough Slider Bearing

Analysis of non-uniform load distribution and stiffness for a preloaded roller linear motion guide

A methodology for energy dissipation prediction of the bolt group with non-uniform preload