Abstract:This article presents an investigation into the effects of natural seawater and sea sand on the behaviour of unconfined and fibre-reinforced polymer-confined concrete. The experimental programme covered compression tests of a large number of standard concrete cylinders, which were prepared from the following four series of concrete: (1) the reference normal concrete, (2) sea-sand concrete, (3) seawater concrete (SwC), and (4) seawater sea-sand concrete. The concrete cylinders were either unconfined or confined with externally wrapped carbon fibre-reinforced polymer jackets to be tested at various ages from the early to the long term. This article presents the results of the first-phase tests, which covered a total of 48 specimens from the four series of concrete, with a half of them tested in the unconfined condition at the ages of 7 and 28 days, and another half tested with either one-ply or two-ply carbon fibre-reinforced polymer jackets at 28 days. The results show that at the ages of 7 and 28 days, the unconfined concrete specimens prepared with seawater and/or sea sand developed a slightly higher compressive strength, as compared to those prepared from normal concrete. When confined with carbon fibre-reinforced polymer jackets, the compressive stress–strain responses of concrete with or without seawater and/or sea sand were very similar. The use of seawater and sea sand did not seem to have significant effects on the compressive strength, ultimate axial strain and stress–strain responses of confined concrete, and the ultimate strain capacity of carbon fibre-reinforced polymer jackets neither. The test results were also compared with the predictions of an existing analysis-oriented stress–strain model for fibre-reinforced polymer-confined concrete. It is shown that the compressive strength, ultimate axial strain, stress–strain responses and dilation behaviour of the carbon fibre-reinforced polymer-confined concrete with or without seawater/sea sand can be reasonably well predicted.

Effects of polymer and bentonite support fluids on concrete-sand interface shear strength

Effects of Natural Seawater and Sea Sand on the Compressive Behaviour of Unconfined and Carbon Fibre-Reinforced Polymer-Confined Concrete

Effect of drilling fluid on concrete-soil/rock interface shear strength in seawater drilling environment

The Effect of Cemented Soil Strength on the Frictional Capacity of Precast Concrete Pile–cemented Soil Interface

Laboratory tests on the frictional capacity of core pile - cemented soil interface

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Shaft Capacity of the Pre-Bored Grouted Planted Pile in Dense Sand

Experimental study on frictional capacity of square pile-cemented soil interface

Experimental Study on Friction Capacity of Pile-Stabilized Soil Interface

The frictional capacity of smooth concrete pipe pile–cemented soil interface for pre-bored grouted planted pile

Behavior of Sand Filled Nodular Piles under Compression in Soft Soil Areas

The behavior of polymer-bentonite interface under shear stress

Influence of Soil Reinforcement on the Uplift Bearing Capacity of a Pre-Stressed High-Strength Concrete Pile Embedded in Clayey Soil

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Effect of Bentonite Content and Hydration Time on Mechanical Properties of Sand–Bentonite Mixture

Degradation effect of seawater on the long-term dynamic behavior of artificially cemented sand

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

Experimental Study on Direct Shear Performance of Concrete-Concrete Interface of Prefabricated Structure Sleeve Grouting Connection

Dynamic Shear Behavior of Interface for Clay Reinforced with Geogrid Encapsulated in Thin Layers of Sand

Effects of water content on shear properties of bentonite–polymer composite structure

Test and prediction for the shear behavior of the sand–irregular concrete interface under constant and dynamic normal loading