Influence of a Separation Grid on the Efficiency of Particulate Matter Capture in a Device with Arc-Shaped Elements

E. I. Salakhova,V. E. Zinurov,O. S. Dmitrieva,A. V. Dmitriev,A. A. Abdullina

DOI: https://doi.org/10.1134/s0040579524601109

2024-11-01

Theoretical Foundations of Chemical Engineering

Abstract:In the chemical industry, moving fluidized bed adsorbent plants are widely used due to the high intensity of interaction between the streams. In this case, particles formed as a result of collision with each other and with the reactor wall need to be removed from the exhaust gases. This requirement is caused by a number of factors: the reduced operating efficiency of subsequent installations, the erosive wear of equipment mechanisms, the loss of part of the catalyst, etc. In the work, a separation device design is proposed with arc-shaped elements for separation of dispersed particles and gas. A three-dimensional model of the device is presented and its principle of operation is described. It is shown that one of the problems of its application is upward parasitic flows returning the captured particles back into the flow. To solve the problem, a separation grid is proposed. This work aims to investigate the influence of the separation grid design on the capture efficiency of solid particles in the device with arc-shaped elements. Three cases are considered to establish how the linear dimensions of the separation grid influence the particle capture efficiency: (i) the height of the upper part of the grid h 1 increased from 10 to 60 mm, the height of the lower part of the grid h 2 decreased from 90 to 40 mm, and the grid height h gr remaining constant; (ii) the height h 1 increased from 10 to 60 mm, the height h 2 remaining constant, and the height h gr increased from 100 to 150 mm; and (iii) the height h 1 increased from 10 to 110 mm, the height of h 2 decreased from 90 to 40 mm, and the height h gr increased from 100 to 150 mm. The study is performed by numerical simulation in the Ansys Fluent software package. In the study, the dust-laden gas velocity is set to 1 m/s at the inlet to the device and the atmospheric pressure is set at the outlet of the device. Based on the conducted studies, it is found that the use of a separation grid provides an increase in the particle capture efficiency, since it blocks parasitic upward flows to a greater extent. The separation device efficiency in capturing particles of 10 to 170 μm in size at the dust-laden gas inlet velocity of 1 m/s is 88.6% on average. The efficiency of the device with arc-shaped elements is maximized when the ratio of the upper part to the lower part of the separation grid is h 1 / h 2 ≥ 5/7.

engineering, chemical