Abstract:Optical gains at 637 nm wavelength using light‐emitting diodes (LEDs) instead of traditional semiconductor lasers as pumping sources are obtained in thermally activated delayed fluorescent (TADF) molecule doped polymer waveguides. These optical waveguide amplifiers show great potential for low‐cost and universal applicability in photonic integrated chips. Optical gains at 637 nm wavelength using light‐emitting diodes (LEDs) instead of traditional semiconductor lasers as pumping sources are demonstrated in the organic molecule 2,6‐bis[4‐(diphenylamino)phenyl]‐9,10‐anthracenedione (AQ(PhDPA)2)‐doped polymethylmethacrylate (PMMA) and SU‐8 polymer waveguides. Under excitation of four blue‐violet LEDs with different central wavelengths, fluorescence in the red band is observed owing to the transition of AQ(PhDPA)2 from the excited states to the ground state based on the thermally activated delayed fluorescence (TADF) mechanism. Channel waveguides with a cross‐section of 6 μm × 5 μm are fabricated. The relative gains of 5.0 and 4.0 dB cm−1 are obtained in rectangular waveguides with active core layers as AQ(PhDPA)2 doped PMMA and SU‐8, respectively. Optical gains have also been achieved in waveguides based on evanescent‐wave coupling. By using the vertical top pumping mode of a 450 nm LED, a gain of 2.6 dB cm−1 is obtained in a passive SU‐8 waveguide with AQ(PhDPA)2 doped PMMA as the upper cladding. In contrast, the replacement of SU‐8 with AQ(PhDPA)2 doped SU‐8 as the active material, triples the optical gain, which reaches to 7.8 dB cm−1 owing to the presence of stimulated excitation in both channel waveguide and upper cladding.

Gain enhancement technique for S-band polymer-based waveguide amplifiers

A strategy for preparing broadband polymer based optical waveguide amplifiers: doping low crystal field symmetric nanocrystals in polymer matrix as gain media

Boosting the Downconversion Luminescence of Tm 3+ -Doped Nanoparticles for S-Band Polymer Waveguide Amplifier

Toward a10 dB net-gain waveguide amplifier in an Er3+-Yb3+ co-doped phosphate glass

Toward a 10 Db Net-Gain Waveguide Amplifier in an Er3+-Yb3+ Co-Doped Phosphate Glass

High‐Gain of NdIII Complex Doped Optical Waveguide Amplifiers at 1.06 and 1.31 μm Wavelengths Based on Intramolecular Energy Transfer Mechanism (Adv. Mater. 12/2023)

Strip loaded waveguide amplifiers based on erbium-doped nanocomposites with 17 dB internal net gain

Monolithic integration of waveguide amplifiers and passive polymer photonic devices using photolithography

Optical Gain at 637 nm Wavelength in Polymer Waveguide Amplifier Under Commercial LED Pumping for Planar Photonic Integration

Design of a broadband Si_3N_4 waveguide amplifier based on a gain medium of ion-sliced titanium-doped sapphire

On-chip Er-doped Ta_2O_5 waveguide amplifiers with a high internal net gain

Design of a Broadband Si3N4 Waveguide Amplifier Based on a Gain Medium of Ion-Sliced Titanium-Doped Sapphire.

Dye Gain Gold NW Array of Surface Plasmon Polariton Waveguide

Design of Raman-Parametric Fiber Amplifier for Wavelength Division Multiplex Transmission System

Design of a Few-Mode Erbium-Ytterbium Co-Doped Polymer Optical Waveguide Amplifier With Low Differential Modal Gain

High Gain, Low Noise, Spectral-Gain-Controlled, Broadband Lumped Fiber Raman Amplifier

Improvement of differential modal gain in a ring-core few-mode erbium-doped polymer optical waveguide amplifier

Monolithic Integrated Waveguide Device with Dual Functions of Electro-Optic Modulation and Optical Amplification.

Er 3+ /Ce 3+ Co-doped Phosphosilicate Fiber for Extend the L-band Amplification

A Low-Fabrication-Temperature Erbium-Based Waveguide Amplifier

Effect of inorganic compound size on the relative gain of polymer-based optical waveguide amplifiers